transmission AUDI A4 1995 B5 / 1.G APB Engine Electronic Engine Power Control Checking Workshop Manual

24-165

- Repair any open/short circuit as necessary.
If no wiring malfunction is detected:

- Replace accelerator position sensors.

Note:
After replacing accelerator position sensor, on
vehicles with automatic/stepless transmission
carry out adaptation of Kick-Down switch
Page 24
-166
.
Pa
ge 34 of 39 Electronic En
gine Power Control
(EPC
), checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.4

24-166

Kick-Down function, adaptation

On vehicles with automatic/inifinitely variable
transmission, when the accelerator position
sensor or the Engine Control Module (ECM) was
replaced, the Kick-Down function from ECM must
be adapted.

Test conditions

No malfunctions stored in DTC memory
Page 01
-15
, check DTC memory

Engine not running, ignition switched on

- Connect vehicle diagnostic, testing and
information system VAS 5051 or VAG1551 scan
tool and select engine electronics control
module by entering address word "01" Page 01
-9 .

When doing this the ignition must be switched
on.
Pa
ge 35 of 39 Electronic En
gine Power Control
(EPC
), checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.24.4