wiring AUDI A4 1995 B5 / 1.G AWM Engine Assembly Workshop Manual

13-3


Removing
Repair Manual, Body Exterior, Repair Group 63
- Remove sound insulation Fig. 1
, Page
13
-6
- Remove front bumper:- Remove lower air duct hose to charge air cooler
Fig. 2
, Page 13
-6
- Remove air duct between lock carrier and air
filter Fig. 3
, Page 13
-7
- Remove retaining clips (if installed) for wiring
harness on left at radiator shroud.
Pa
ge 3 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1

13-5


Installing
Installation is carried out in the reverse order of
removal; note the following:
Repair Manual, Body Exterior, Repair Group 63

Repair Manual, Electrical Equipment, Repair
Group 94
- When lock carrier has been installed, check that
wiring next to radiator is correctly routed.
- Adjust limit stop for torque reaction support
Fig. 4 , Page 13
-7 .
- Install front bumper.- Adjust headlights.
Pa
ge 5 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1

13-11


14 -
Generator
Removing:
- Disconnect battery Ground strap
- Remove air duct hose to charge air
cooler.
- Loosen ribbed belt and take belt off
Generator Page 13
-18
.
- Remove viscous fan and put into radiator
cowl.
- Remove electrical wiring from Generator.
- Loosen connections for Generator from
top and bottom and remove Generator.
Installing:
- To facilitate attachment of Generator
slightly drive back thread bushing for
securing bolt at bracket.
Pa
ge 11 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1

13-30


- To loosen ribbed belt, turn tensioner in direction of arrow.
- Remove ribbed belt from Generator pulley.

- Secure pulley for viscous fan with pin punch -1- and remove using
Allen key -2-.
- Remove viscous fan from mounting and put in front of radiator cowl.
- Remove wiring from rear of Generator.
- Loosen connections for Generator from top and bottom and remove
Generator.
Pa
ge 30 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1