ABS AUDI A4 1995 B5 / 1.G Brakes Output DTM 03 Owner's Guide

01-187
Diagnostic Trouble Code (DTC) table

Notes:

Fulfill test requirements page 01
-22
.
Connect the VAG1551 Scan Tool (ST) and select "Brake Electronics" via address word 03 page 01
-4 .
Check the control module version page 01
-128
and press the button.
Press buttons -0- and -2- to select "Check DTC Memory" function 02. Press -Q- button to confirm input.
Notes:
Each malfunction is assigned a 5-digit Diagnostic Trouble Code (DTC). The DTC is located in the left column of the DTC
table. If you have switched the printer on by pressing the "PRINT" button, the VAG1551 scan tool (ST) prints the message
identifying the malfunction and the DTC. Otherwise, DTCs are not displayed by the VAG1551 scan tool.
The contents of DTC memory remain stored until memory is erased, page 01
-15
.
Sporadically occurring malfunctions are identified via indication of "/SP" on the right-hand side of the display.
Static malfunctions that cannot be detected when the vehicle is stationary are also identified with "/SP" if the ignition has
been switched off and then on again.
The following DTC table includes all the DTCs that can be stored by the ABS control module -J104- and displayed and
printed out by the VAS5051 tester or VAG1551 scan tool. Malfunctions are listed by DTC number.
Pa
ge 42 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-188

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool (ST)

00000
No malfunction recognized!
If this display appears,
process is concluded. No
DTCs are stored in DTC
memory.
If corresponding warning
lamps light up anyway, check
the following points:
Voltage supply for ABS control module -
J104- below 10.0 volts at a vehicle speed
less than 6 km/h. Open circuit in activation wire for ABS
warning light -K47- between ABS control
module (w/EDL) -J104- and instrument
cluster combination processor -J218-. - See section "Overview of indicator lamp
functions" page 01
-120
.
If no malfunction can be found, and there is still
a problem, there may be a mechanical
malfunction (e.g. solenoid valve sticking). - Expand troubleshooting to include
output Diagnostic Test Mode (DTM)
page 01
-149
and the "Electrical test"
page 01
-166
.
Pa
ge 43 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-189

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00283
Left front ABS wheel
speed sensor -G47-1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G47- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G47-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 40
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 5 page 01
-166
.
Left front ABS wheel
speed sensor -G47-
Open circuit/short
circuit to B+
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G47- and ABS control module -
J104-. - If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 44 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-190

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00285
Right front ABS
wheel speed sensor
-G45-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G45- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G45-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 40
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 4 page 01
-166
.
Right front ABS
wheel speed sensor
-G45-
Open circuit/short
circuit to B+
Incorrect control module version.
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G45- and ABS control module -
J104-. - Check control module version page 01
-128
.
- If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 46 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-191

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00287
Right rear ABS
wheel speed sensor
-G44-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G44- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G44-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 42
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 6 page 01
-166
.
Right rear ABS
wheel speed sensor
-G44-
Open circuit/short
circuit to B+
Incorrect control module version.
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G44- and ABS control module -
J104-. - Check control module version page 01
-128
.
- If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 48 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-192

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00290
Left rear ABS wheel
speed sensor -G46-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G46- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G46-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 42
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 7 page 01
-166
.
Left rear ABS wheel
speed sensor -G46-
Open circuit/short
circuit to B+
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G46- and ABS control module -
J104-. - If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 50 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-193

DTC
Possible cause
Corrective action
Printed output from VAG1551 Scan
Tool (ST)

00301
ABS return flow pump -V39 -
Malfunction in hydraulic
control unit - Erase DTC memory page 01
-15
- End Output page 01
-16
.
- Switch off ignition.
- Switch on ignition

- If malfunction occurs again, replace hydraulic
control unit.
Pa
ge 52 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-194

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool (ST)

00526
Brake light switch -F-
Open circuit

Both brake lights -M9- (left) and -
M10- (right) malfunctioning.
Wire from brake lights to control
module faulty.
ABS control module -J104-
malfunctioning
Electrical Wiring Diagrams, Troubleshooting &
Component Locations - Check brake light switch, "Read measuring value
block", display group 2 page 01
-140
.
- Locate and repair open circuit or short circuit.
- Replace bulbs.
Pa
ge 53 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-195

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00529
Wheel speed information
missing


This malfunction only
occurs if vehicle is
equipped with ASR. Data is transferred between the ABS
control module -J104- and the Engine
Control Module (ECM) via a single wire. For more information, see the section "Systems
related to ASR" page 01
-42
and the table
"Control module versions" page 01
-134
.
See continuation on next
page


Open circuit or short circuit to B+ or
Ground (GND) in wire between ABS
control module -J104- and Engine
Control Module (ECM). Electrical Wiring Diagrams, Troubleshooting &
Component Locations - Locate and repair open circuit or short circuit.


Engine Control Module (ECM)
malfunctioning. - If the tachometer in the instrument cluster is
malfunctioning and no malfunctions can be found
in the wiring, the Engine Control Module (ECM)
is malfunctioning.

ABS control module -J104-
malfunctioning - If the tachometer in the instrument cluster
functions properly and no malfunctions can be
found in the wiring, the ABS control module
Pa
ge 54 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-196

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00529
Wheel speed information
missing

Continuation: Data is transferred between ABS
control module -J104- and Engine
Control Module (ECM) via the
CAN-bus. For more information, see the section "Systems related
to ASR" page 01
-42
and the table "Control module
versions" page 01
-134
.
This malfunction only
occurs if vehicle is
equipped with ASR.


The Engine Control Module
(ECM) is not able to provide the
engine speed (RPM) signal for
the CAN-bus. - Check DTC memory of Engine Control Module (ECM).
If there is a malfunction, fix it according to the
appropriate engine Repair Manual and erase DTC
memory of the Engine Control Module (ECM).
- If there are no DTCs stored in the Engine Control
Module (ECM), replace the Engine Control Module
(ECM) as a test.

The ABS control module
(w/EDL) -J104- is not able to
evaluate the engine speed
(RPM) signal for the CAN-bus. - If the steps listed above do not repair the malfunction,
replace the ABS control module -J104-.
Pa
ge 56 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13