engine AUDI A4 1996 B5 / 1.G 01A Transmission Clutch Mechanism Service Workshop Manual

30-1


Clutch mechanism, servicing

CAUTION!

Before disconnecting the battery:

Determine the correct coding for the anti-
theft radio.
Switch the ignition off (also applies when
connecting the battery). Failure to do so may
damage the Engine Control Module (ECM).
Part numbers are listed here for reference
only. Always check with your Parts
department for the latest information.

Notes:
Lubricate all bearings and contact surfaces with
G 052 142 A 2 polycarbamide grease.


Before
working on
the pedal
cluster,
remove the
driver's side
storage
compartment
Pa
ge 1 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1

30-7


Clutch Pedal Position (CPP) switch -F194-,
removing and installing

Note:
The clutch pedal position switch -F194- allows the
engine to be started only with the clutch pedal
depressed. Introduction 05.97
1 -
Mounting bracket
Before removing, remove steering column
from steering gear Repair Manual, Suspension, Wheels, Steering, Repair Group 48

2 -
Cable bracket
3 -
Locking clip
4 -
Pin and locking plate
Latched in clutch pedal
5 -
Clutch pedal Removing and installing Page 30
-5
6 -
Clip
Pa
ge 8 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1

30-13

Clutch master cylinder, removing and
installing


Special tools and equipment
3094 hose clamp

Removing

CAUTION!

Before working on the electrical system:

Determine the correct coding for the anti-
theft radio.
Switch the ignition off (also applies when
connecting the battery). Failure to do so may
damage the Engine Control Module (ECM).
Disconnect the battery Ground (GND)
strap.
To remove E-box from plenum chamber:

- Remove bolts (arrows) and remove cover.
- Remove Engine Control Module (ECM); if necessary remove 8-pin
relay support Repair Manual, Electrical Equipment, Repair Group 97- Disconnect harness connectors at connector station.
Pa
ge 14 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1

- Remove engine wiring harness together with rubber grommet from
opening in E-box.
Pa
ge 15 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1