belt AUDI A4 1996 B5 / 1.G APB Engine Lubrication System Components User Guide

17-57


- Remove 4 bolts from upper section of oil pan.

- Remove following components before unbolting front sealing flange:
1 - Tensioning roller for toothed belt: 20 Nm
2 - Idler wheel: 45 Nm
3 - Toothed belt tensioner: 10 Nm
4 - Lever for toothed belt tensioner: 20 Nm
Pa
ge 62 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1

17-63

Crankshaft oil seal - pulley end,
replacing


Removing

- Remove bumper.

Repair Manual, Body Exterior, Repair Group
63


- Move lock carrier to service position

Repair Manual, Body Exterior, Repair Group
50


- Remove ribbed belt Page 13
-1 .

- Remove toothed belt Page 13
-4 .

- Remove sealing plug from hole in cylinder block
(left side).

-
Position crankshaft to TDC of No. 3 cylinder.
Crankshaft TDC drilling should be visible (or it
should be possible to feel the drilling) in sealing
Pa
ge 68 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1

17-64

- Remove crankshaft toothed belt sprocket.

- Remove inner part of oil seal extractor 3203 two
turns (approx. 3 mm) out of outer part and lock
with knurled screw.

Installing - Lubricate threaded head of oil seal extractor, place it in position and,
exerting firm pressure, screw it in as far as possible into oil seal.
- Loosen knurled screw and turn inner part against crankshaft until oil
seal is pulled out.
- Place guide sleeve 3202/1 onto crankshaft journal.
- Slide dry seal over guide sleeve.

Then proceed as for removing, performing steps in reverse order. - Press oil seal in flush with installing sleeve 3265.
Pa
ge 70 of 74 Lubrication s
ystem com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.17.1