19-7
      
Filling  
     
Note:  
     
The cooling system is filled all year round with a 
mixture of water and an antifreeze/corrosion 
protection agent. 
     Only use coolant additive G 012 A8 D meeting 
specification TL VW 774 D. Identification color: 
red 
     
CAUTION! 
     
G 012 A8 D and other coolant additives 
cannot be mixed. Otherwise, serious damage 
to the engine may result. 
     If the fluid in the expansion tank is brown, this 
means G 012 A8 D has been mixed with 
another type of coolant. In this case, flush out 
the cooling system and fill with fresh coolant. To 
flush the system, fill it with clean water and run 
the engine for about 2 minutes. This should 
remove as much of the old coolant as possible. 
     G 012 A8 D and coolant additives marked 
"meeting specification TL VW 774 D" prevent 
frost and corrosion damage and stop scaling 
while at the same time raising the boiling point 
of the coolant. For these reasons the cooling 
Pa
ge 8 of 38 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.19.1 
         19-8
      
Because of its high boiling point, the coolant 
improves engine reliability under heavy loads, 
particularly in countries with tropical climates. 
     Protection against frost must be assured to 
about -25 C (in arctic climatic countries to 
about -35 C). 
     
The coolant concentration must not be reduced 
by adding water, even in warmer seasons and 
in warmer countries. The anti-freeze ratio must 
be at least 40 %. 
     If greater frost protection is required in very cold 
climates, the amount of G 012 A8 D can be 
increased, but only up to 60% (this gives frost 
protection to about -40 C). Otherwise, frost 
protection is reduced again and cooling 
effectiveness is also reduced. 
     
Only use clean drinking water for mixing the 
coolant. 
     If radiator, heat exchanger, cylinder head or 
cylinder head gasket is replaced, do not reuse 
old coolant. 
     Use special tool T10007 to check frost 
protection of coolant additive G012 A8 D in 
Pa
ge 10 of 38 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.19.1