AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual https://www.carmanualsonline.info/img/6/1237/w960_1237-0.png AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual

Page 1 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-1
 
     
Drive flange seal, replacing 
     
Transmission installed 
     
-  Observe general repair instructions   Page 00
-
14
 . 
     
Special tools and equipment  
     
VW195 arbor 
     VW2

Page 2 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual      
Transmission code CXF: drive flanges are 
installed without polygon bearings. 
     For drive flanges with a gear diameter of 30 mm 
(1.181 in.) a spacer ring is installed between the 
polygon b

Page 3 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-2
      
Removing  
     
-  Remove heat shield for drive axle.
     
-  Remove drive axle from transmission drive 
flange. 
     
       Repair Manual, Suspension, Wheels, 
Steering, Repair Group

Page 4 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-3
 
    
-  Always replace circlip for drive flange.
-  Clamp drive flange in vise using protective jaws and remove circlip by 
pressing new circlip -A- into groove. 
-  Remove drive flange seal us

Page 5 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-4
 
    
Setup of drive flange with polygon bearing  
Notes:  1 - Drive flange
2 - Needle bearing (Polygon bearing)
3 - Spacer ring
4 - Circlip
5 - Spacer ring (is installed additionally if spline

Page 6 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-5
      
Installing  
     
-  Fill space between sealing lip and dust lip with 
gear oil. 
     
-  Lightly oil outer circumference of seal.
    
Note:  
If reinstalling an old drive flange, the n

Page 7 of 7

AUDI A4 1997 B5 / 1.G 01A Transmission Final Drive Flange Seal Workshop Manual 39-6
      
-  Install drive axle heat shield.
     
-  Check transmission oil level   Page 34
-38
 .
     
Tightening torques  
     
Component  
  
Nm (ft lb)  
Drive axle to drive 
flange  M8   40