torque AUDI A4 1997 B5 / 1.G 01A Transmission Front Differential Assembly Workshop Manual

39-24


5 -
Ring gear*
Is matched to pinion shaft (gear set)Allocate by transmission code parts
catalog, Page 00
-3
Remove from differential housing using a
drift Fig. 9

Installing on differential housing Fig. 10
6 -
Differential housing*
Allocate by transmission code parts
catalog Transmission identification Page 00
-3
7 -
Ring gear bolt
Always replaceLightly tighten bolts, then tighten diagonally
to correct torque 60 Nm (44 ft lb) + 1/4-turn (90 )
Pa
ge 5 of 14 Front final drive differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.5

39-32


WARNING!
Wear protective gloves. Fig. 10 Installing ring gear
- When installing ring gear, guide with centering pins -A- (local
manufacture).
-
Heat ring gear to approx. 100 C (212 F) and install.- Allow ring gear to cool off slightly before inserting bolts.
- Tighten to specified torque.

Fig. 11 Installing differential bevel gears
- Lubricate one-piece thrust washer with transmission oil and install.
- Install large differential bevel gears.
-
Insert small differential bevel gears at 180 from their final position,
and rotate into place (arrow). - Drive small differential bevel gear shaft into final position and secure.
Pa
ge 13 of 14 Front final drive differential, disassemblin
g and assemblin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.5