ECU AUDI A4 1997 B5 / 1.G 01A Transmission Input Shaft Assembly Workshop Manual

35-3


5 -
Needle bearing for input shaft
Secured with bolt Fig. 1Driving out Fig. 2Application of input shaft/needle bearing
Fig. 3

Allocation Fig. 4Pressing in Fig. 5
6 -
Input shaft
With oiling sleeveDriving in oiling sleeve Fig. 6Application of input shaft/needle bearing
Fig. 3

Adjusting Page 35
-17
7 -
Needle bearing for 3rd gear
8 -
3rd gear
9 -
Spring
Inserting in 3rd gear Fig. 12Application of spring to gear Parts
catalog
10 -
Synchronizer ring for 3rd gear
Checking for wear Fig. 13
Pa
ge 4 of 17
11/19/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p\triJBHHO.htm

35-6


Fig. 1 Securing bolt for needle bearing
- Remove securing bolt (arrow).

Fig. 2 Driving out needle bearing
Pa
ge 7 of 17
11/19/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p\triJBHHO.htm

35-8


Fig. 5 Pressing in needle bearing
- Install securing bolt and tighten to 25 Nm (18 ft lb).

Installed position Fig. 6 Driving in oiling sleeve into input shaftItem
Dia. of oiling sleeve
Tool
A 14 mm (0.551 in.) VW222A pilot drift
B 16 mm (0.629 in.) 30-24 drift
Flared edge of oiling sleeve faces installation toolAllocation: 3.5 mm (0.138 in.) below upper edge
Pa
ge 9 of 17
11/19/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p\triJBHHO.htm

35-13


Fig. 14 Allocation of circlips
The circlips -1- and -2- secure the input shaft ball bearing.
Determining thickness Page 35
-17
, input shaft, adjusting
The circlip -3- secures the 3rd and 4th gear synchronizer hub.
Thickness: 2.00 mm (0.078 in.)
Identification: brown color
The circlip -4- secures the 3rd and 4th gear synchronizer hub.
Determining thickness Page 35
-14
, table
Identification: blue color
The circlip -5- secures the 5th gear.
Determining thickness Page 35
-14
, table
Pa
ge 14 of 1711/19/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p\triJBHHO.htm