oil AUDI A4 1997 B5 / 1.G AHA ATQ Engines Cooling System Components Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1997, Model line: A4, Model: AUDI A4 1997 B5 / 1.GPages: 40, PDF Size: 0.77 MB
Page 10 of 40

19-8
21 -
Lower coolant line
Coolant hose connection diagram page 19
-9
22 -
Oil cooler
23 -
Belt pulley
For viscous fan
24 -
Fan wheel for viscous fan
25 -
Viscous fan coupling Note left-hand threadTightening torque only valid when using
3312 open end spanner. Tighten to 40 Nm (30 ft lb)Removing and installing page 19
-25
26 -
Bracket
For viscous fan
27 -
From bottom of radiator Coolant hose connection diagram page 19
-9
Pa
ge 10 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 12 of 40

19-10
9 -
Oil cooler
10 -
Coolant line
From expansion tank to lower coolant pipe
11 -
Upper coolant hose
12 -
Radiator
13 -
Coolant pump
14 -
Lower coolant line
15 -
Connection For thermostat
Pa
ge 12 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 15 of 40

19-12
Filling
Notes: - Drain engine coolant at drain plug (arrow).
Only use coolant additive G12 (according to TL VW 7745 D). G12 is
red in color. Do not mix G12 with any other coolant additive!If the fluid in expansion tank is brown, G12 has been mixed with other
coolant. In this case, the coolant must flushed and replaced. "G12" and coolant additives marked in accordance with "TL VW 774
D" prevent frost and corrosion damage, scaling and also raise the
boiling point of the coolant. Therefore, the cooling system must be
filled year round with frost and corrosion protection additives. A higher boiling point improves engine reliability under heavy load
particularly in countries with tropical climates. Frost protection additives protect against frost to about -25 C (about -
35 C in arctic climates). The coolant concentration must not be reduced by adding water even
in warmer seasons and in warmer countries. The anti-freeze ratio
must be at least 40%.
Pa
ge 15 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 22 of 40

19-18
All models
Vehicles with air conditioning
CAUTION! - Unbolt power steering hydraulic oil cooling line (arrows).
DO NOT open the air conditioning refrigerant circuit.Disconnect A/C refrigerant lines at brackets and support points
only. Avoid damage from bending. Refrigerant lines kink easily.
- Unbolt air guides at radiator -4- on left and right-sides.
- Unbolt retaining bolts -1- and -2- from condenser.
- Disconnect harness connector -3- at A/C pressure switch -F129-.
- Pull condenser upward out of retaining bracket, swing to side and hang
at right-front wheel using wire loop.
Pa
ge 22 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 27 of 40

19-22
Installing
Installation is the reverse of removal, noting the
following:
- Remove any remaining sealant from sealing
surfaces of coolant pump and cylinder block.
- Clean sealing surfaces so they are completely
free of any oil or grease.
- Install new gasket on water pump flange.
- Install coolant pump -2- into cylinder block and tighten all 9 mounting
bolts (arrow -2-) to 10 Nm (7 ft lb).
- Install rear toothed belt guard on water pump housing (arrow -1-).
Tightening torque: 10 Nm (7 ft lb).
- Install and tension toothed belt page 13
-12
.
- Install toothed belt guard.
- Install ribbed belt page 13
-8 .
- Fill cooling system with coolant page 19
-11
.
Pa
ge 27 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1
Page 37 of 40

19-31
6 -
Spring clamp
7 -
Coolant hose
8 -
Spring clamp
9 -
Electrical after-run coolant pump
Checking page 19
-32
Removing and installing page 19
-34
10 -
10 Nm
11 -
Spring clamp
12 -
Coolant hose
13 -
Spring clamp
14 -
Connection
For thermostat
15 -
Oil cooler
16 -
Oil filter
Pa
ge 37 of 40 Coolin
g system com
ponents, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.19.1