AUDI A4 1997 B5 / 1.G Brakes Output DTM 03 Service Manual

01-186

Function test: Traction control button; set measurement range on VAG1526: 20 V =
Test step
VAG
1598
sockets Test of
Test requirements
- Additional work
steps Specified
value Corrective action
11 19 + 31 Function of
traction control
button Ignition switched
on.
Continuation:
- Traction control
button not pressed 0.0 -0.5 V

- Traction control
button pressed 10.0 - 14.5
V
Electrical Wiring Diagrams,
Troubleshooting & Component Locations
- Check wire from terminal 19 to Ground
(GND).
- Check wire from terminal 31 to traction
control button, terminal 6.
- Check voltage supply from terminal 5
of traction control button to terminal 15.
- If no malfunctions can be found using
the procedures in these steps, replace
the traction control button.
Pa
ge 41 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-187
Diagnostic Trouble Code (DTC) table

Notes:

Fulfill test requirements page 01
-22
.
Connect the VAG1551 Scan Tool (ST) and select "Brake Electronics" via address word 03 page 01
-4 .
Check the control module version page 01
-128
and press the button.
Press buttons -0- and -2- to select "Check DTC Memory" function 02. Press -Q- button to confirm input.
Notes:
Each malfunction is assigned a 5-digit Diagnostic Trouble Code (DTC). The DTC is located in the left column of the DTC
table. If you have switched the printer on by pressing the "PRINT" button, the VAG1551 scan tool (ST) prints the message
identifying the malfunction and the DTC. Otherwise, DTCs are not displayed by the VAG1551 scan tool.
The contents of DTC memory remain stored until memory is erased, page 01
-15
.
Sporadically occurring malfunctions are identified via indication of "/SP" on the right-hand side of the display.
Static malfunctions that cannot be detected when the vehicle is stationary are also identified with "/SP" if the ignition has
been switched off and then on again.
The following DTC table includes all the DTCs that can be stored by the ABS control module -J104- and displayed and
printed out by the VAS5051 tester or VAG1551 scan tool. Malfunctions are listed by DTC number.
Pa
ge 42 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-188

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool (ST)

00000
No malfunction recognized!
If this display appears,
process is concluded. No
DTCs are stored in DTC
memory.
If corresponding warning
lamps light up anyway, check
the following points:
Voltage supply for ABS control module -
J104- below 10.0 volts at a vehicle speed
less than 6 km/h. Open circuit in activation wire for ABS
warning light -K47- between ABS control
module (w/EDL) -J104- and instrument
cluster combination processor -J218-. - See section "Overview of indicator lamp
functions" page 01
-120
.
If no malfunction can be found, and there is still
a problem, there may be a mechanical
malfunction (e.g. solenoid valve sticking). - Expand troubleshooting to include
output Diagnostic Test Mode (DTM)
page 01
-149
and the "Electrical test"
page 01
-166
.
Pa
ge 43 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-189

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00283
Left front ABS wheel
speed sensor -G47-1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G47- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G47-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 40
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 5 page 01
-166
.
Left front ABS wheel
speed sensor -G47-
Open circuit/short
circuit to B+
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G47- and ABS control module -
J104-. - If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 44 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

1) This malfunction can only be detected when the vehicle is moving
Pa
ge 45 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-190

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00285
Right front ABS
wheel speed sensor
-G45-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G45- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G45-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 40
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 4 page 01
-166
.
Right front ABS
wheel speed sensor
-G45-
Open circuit/short
circuit to B+
Incorrect control module version.
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G45- and ABS control module -
J104-. - Check control module version page 01
-128
.
- If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 46 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

1) This malfunction can only be detected when the vehicle is moving
Pa
ge 47 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-191

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00287
Right rear ABS
wheel speed sensor
-G44-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G44- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G44-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 42
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 6 page 01
-166
.
Right rear ABS
wheel speed sensor
-G44-
Open circuit/short
circuit to B+
Incorrect control module version.
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G44- and ABS control module -
J104-. - Check control module version page 01
-128
.
- If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 48 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

1) This malfunction can only be detected when the vehicle is moving
Pa
ge 49 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13

01-192

DTC
Possible cause
Corrective action
Printed output from
VAG1551 Scan Tool
(ST)

00290
Left rear ABS wheel
speed sensor -G46-
1)
Mechanical
malfunction
or:
Left rear ABS wheel speed sensor -
G46- installed incorrectly.
ABS wheel speed sensor rotor dirty or
damaged.
Excessive wheel bearing play.
ABS wheel speed sensor -G46-
malfunctioning.
Short circuit to Ground (GND). Repair Manual, Brake System, Repair Group 45

Repair Manual, Brake System, Repair Group 45
Repair Manual, Suspension, Wheels, Steering,
Repair Group 42
- Check installation of ABS wheel speed sensor.
- Check rotor, clean or replace- Replace wheel bearing- "Read measuring value block" display group 1
page 01
-140
.
- Carry out "Electrical test", step 7 page 01
-166
.
Left rear ABS wheel
speed sensor -G46-
Open circuit/short
circuit to B+
Open circuit or short circuit to B+ in
wiring between ABS wheel speed
sensor -G46- and ABS control module -
J104-. - If nothing is displayed during "Read measuring value
block", and no malfunction could be determined in the
wiring or the ABS wheel speed sensor, replace the
hydraulic control unit.
Pa
ge 50 of 66 Out
put Dia
gnostic Test Mode
(DTM
) (function 03
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU02.01.13