AUDI A4 1997 B5 / 1.G Quattro Fuel Syst

20-102

- Carefully pull cover flange out and put to the
side with supply line connected.

- Disconnect harness connector for fuel level
display on inside of cover flange.

Note: - Pull sensor out of surge housing in fuel tank while simultaneously
pressing latching tab -arrow-.
Illustration shows sensor and surge housing for vehicles with Front-
Wheel Drive. For clarity, the surge housing illustration is shown without tank.
Pa
ge 51 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-103

Installing
Installation is performed in reverse order, when
performing, note the following:

- Install sender for fuel gauge in guide on surge
housing outer section and press down until it
engages Page 20
-97
.

- Connect battery Ground strap with ignition
switched OFF.

- After connecting battery, input radio anti-theft
code

Radio operating instructions
- Operate door windows up to the stop using
window switches.

- Operate all window lifters again for at least 1
second in the "closed" position to activate the
automatic up/down.

- Set the clock.
Pa
ge 52 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-104


Fuel pump, removing and installing

Vehicles with all wheel drive and 1.8 ltr. turbo or
2.8 ltr. engine
Observe Safety measures Page 20
-1 .
Observe Rules of cleanliness Page 20-4 .
Note:
The following steps describe fuel pump
installation. Removal is the reverse of the
installation steps.
Fuel pump lines -1- may not be kinked. Replace
kinked fuel lines and immediately dispose of old
parts.
- Replace O-ring -3-.
- Install fuel supply unit Page 20
-91
.
- Install sender for fuel gauge Page 20
-101
.
Pa
ge 53 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-105


- Vacuum booster -1-, installed position
- Location -A- slide through the flange lock
opening.
- Location A in fuel tank, slide in direction of filler
neck while turning approx. 1 additional turn to
the left Fig. 1
, Page 20
-106
.
- Location B, place (black wire) in fuel tank but do
not yet fasten in surge housing 5.
- Location C (white wire) place in fuel tank, but do
not yet fasten in hose coupling 4.
- Location D place in fuel tank. Ensure it comes to
rest above the thick fuel filler hose in the fuel
tank.
- Attach black wire to surge housing 5.
- Connect white wire 2 to hose coupling 4.
Pa
ge 54 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3

20-106


Fig. 1 Fuel pump, installing
- Turn fuel pump in direction of filler neck, into fuel tank, approx. 1 turn to
the left-arrows-.
Pa
ge 55 of 55 Fuel su
pp
ly system, servicin
g (vehicles with all wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.3