torque AUDI A4 1998 B5 / 1.G 01W Transmission Differentila Disassemble And Assemble Workshop Manual

39-19


7 -
Bolt
Always replaceTighten to 60 Nm (44 ft lb) and then tighten
another 45 Lightly tighten bolts then tighten diagonally
to correct torque
8 -
Left tapered roller bearing inner race 1) Left and right tapered roller bearings are
identical (not for transmission without
polygon bearing) Page 00
-3
Pulling off Fig. 6Driving in for transmission with polygon
bearing Fig. 7
, Page 39
-25

Pressing on for transmission without
polygon bearing using 40-21 sleeve
9 -
Drive gear for Vehicle Speed Sensor (VSS)Removing and installing Page 39
-7
Carefully install onto differential without
canting. Do not use force: the drive gear
can break easily.
Pa
ge 6 of 15 Differential, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.4

39-27


WARNING!
Wear protective gloves! Fig. 11 Installing ring gear
- When installing ring gear guide with centering pins -A- (local
manufacture).
-
Heat ring gear to approximately 100 C (212 F) and install.- Before installing bolts, allow ring gear to cool a bit. Then tighten to
specified torque.

Fig. 12 Installing differential bevel gears
- Lubricate one-piece thrust washer with transmission oil before
installing.
- Install large differential bevel gears.
-
Install small differential bevel gears at 180 from their final position
and rotate into place (arrow). - Drive in differential bevel gear shaft to final position and secure.
Pa
ge 14 of 15 Differential, disassemblin
g and assemblin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.4