engine AUDI A4 1998 B5 / 1.G Starter Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1998, Model line: A4, Model: AUDI A4 1998 B5 / 1.GPages: 8, PDF Size: 0.2 MB
Page 2 of 8
27-41
Vehicles with 4-cylinder gasoline
engines
Removing
Vehicles with air conditioning
Repair Manual Body Exterior, Repair Group 63
Repair Manual Body Exterior, Repair Group 50 - Remove noise insulation panel (arrows).
- Remove front bumper.
- Move lock carrier into service position.
Pa
ge 2 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3
Page 5 of 8
27-44
Installing
Installation is the reverse of removal; noting the
following:
Vehicles with air conditioning
- Install ribbed belt for air conditioning
compressor.
All vehicles - Place torque wrench on hex head of belt tensioner as shown and
tighten to 25 Nm (18 ft lb).
- Maintain torque on belt tensioner and tighten bolt -A- to 20 Nm (15 ft
lb).
- Start engine and make sure belt runs properly.
Pa
ge 5 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3
Page 6 of 8
27-45
Vehicles with 6-cylinder gasoline
engines
Removing
Note:
To remove the starter, it is first necessary to
remove the generator Page 27
-26
.
2.7 L/184 kW engine, 5V twin-turbo only
All vehicles - Remove air duct -1-.
2 - Attachment point for oil and refrigerant lines
3 - Engine block mounting point
4 - Hose clamp (loosen)
- Disconnect wire from terminal 30/B+ -2- by removing nut. Tightening
torque: 16 Nm (12 ft lb)
- Disconnect harness connector from terminal 50 -2-.
Pa
ge 6 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3
Page 8 of 8
27-47
Vehicles with automatic transmission
- Remove right-front wheel.
Installing - Upper bolt -1- can be unscrewed from right-front wheel housing.
Tightening torque: 65 Nm (48 ft lb)
- From engine side, remove lower bolt.
Tightening torque: 65 Nm (48 ft lb)
- Remove starter toward front.
- Install starter in reverse order of removal.
Pa
ge 8 of 8 Starter, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.EE01.27.3