transmission AUDI A4 1999 B5 / 1.G 01A Transmission Final Drive Gear Set Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1999, Model line: A4, Model: AUDI A4 1999 B5 / 1.GPages: 31, PDF Size: 0.39 MB
Page 6 of 31
39-152
VW521/4 adjustment for ring gear
VW521/8 adjustment for ring gear
VW540 engine and transmission support
30-205 thrust pad
2003/3 mounting ring
2052/2 assembly tool for pinion shaft
3005 thrust pad
3028 retainer
3062 thrust pad
3253 wheel bearing assembly set with 3253/3
and 3253/4
3304 bracket
VAG1383A engine/transmission
Pa
ge 6 of 31 Final drive
gear set, recommended se
quence for ad
justin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.18
Page 11 of 31
39-155
- Bolt on 3304 bracket with two hex-head bolts M8 x 30.
- Differential must be supported when tightening nut (e.g. using
VAG1359/2 universal mount and transmission hoist VAG1383A).
- Replace pinion shaft nut.
- Tighten pinion shaft nut, until no play can be felt on pinion shaft.
- Increase tightening torque until specified friction torque is attained,
measuring friction torque several times during this process.
1) Must have run at least 50 km (30 miles)
Note:
If the specified friction torque is exceeded, the spacer sleeve must be
replaced and the adjustment repeated. A spacer sleeve that has been
over-compressed at any time cannot be reused. A - Torque gauge, 0-600 Ncm (commercially available)
B - Socket extension, 36 mm
- Adjust friction torque as follows:
New bearings
Used bearings1)
200-250 Ncm (18-22 in. lb) 30-60 Ncm (3-5 in. lb)
Pa
ge 11 of 31 Final drive
gear set, recommended se
quence for ad
justin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.18