light AUDI A4 2000 B5 / 1.G 01V Transmission Oil Pan And Oil Strainer Assembly Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 2000, Model line: A4, Model: AUDI A4 2000 B5 / 1.GPages: 44, PDF Size: 0.83 MB
Page 21 of 44
38-21
Oil strainer, removing and installing
Removing
- Removing oil pan page 38
-19
.
Installing
Tightening torque - Removing oil strainer bolts (arrows).
- Pull oil strainer off of valve body.
- Lightly coat seal on suction collar of oil strainer with ATF.
- Carefully press suction collar of oil strainer into the opening at valve
body up to stop.
- Bolt on oil strainer.
- Installing oil pan page 38
-20
.
- Fill up ATF page 37
-140
.
Component
Nm
Oil strainer to valve body 6
Pa
ge 21 of 44 Oil
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1
Page 25 of 44
38-25
All:
- Remove valve body from transmission while
advancing the wiring harness connector.
Note only for Park/Neutral Position (PNP)
Switch -E17-:
Do not place the removed valve body on the
Sensor for transmission RPM at rear of valve
body. Danger of damage.
Installing
- Lightly coat O-rings of wiring harness connector
with ATF.
- Insert wiring harness connector into
transmission housing.
Installation position: Flat part of rear collar
points downward, the tabs at collar are
horizontal
Only for transmission with hydraulic control
E18/2
- Route wire with connector -C- according to illustration, so that the wire
is not pinched when installing the valve body.
Pa
ge 25 of 44 Oil
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1
Page 30 of 44
38-30
Installing
Installation is reverse of removal, noting the
following:
- Replace O-rings.
Notes: - Insert oil line into 3381 oil line installer.
- Drive oil line into transmission housing by lightly tapping on the 3381 oil
line installer up to stop using a plastic mallet.
The open side of 3381 oil line installer faces toward the outer wall of
the transmission. Do not cant oil line. Drive in both line ends uniformly.
- Installing valve body page 38
-25
.
- Fill up ATF page 37
-140
.
- Checking oil level in front final drive page 39
-1 .
Pa
ge 30 of 44 Oil
pan, oil strainer and valve bod
y, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.38.1