catalytic converter AUDI A4 2000 B5 / 1.G 01V Transmission Select Lever Mechanism Workshop Manual

37-6

Tiptronic shift mechanism, removing
and installing


Removing

- Shift selector lever into position "P".

- Note radio code (for vehicles equipped with
coded anti-theft radio).

- Disconnect Ground (GND) strap from battery.

- Selector lever handle, removing page 37
-
22
.

- Remove shift mechanism cover page 37
-
24
.

- Raise vehicle.

- Disconnect front exhaust pipes with catalytic
converter from the rear exhaust system and tie
them up on side.

Repair Manual, Engine Mechanical, Repair
Group 26, removing and installing exhaust
system.
Pa
ge 8 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-40

Selector lever cable for Tiptronic shift
mechanism, removing and installing


Special tools and equipment

Removing
Repair Manual, Engine Mechanical, Repair Group 26, removing and
installing exhaust system
80-200 Pry lever
- Shift selector lever into position "P".
- Raise vehicle.
- Remove crossmember below exhaust system if installed.
- Disconnect front exhaust pipes with catalytic converter from the rear
exhaust system and tie them up on side;
Pa
ge 45 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1

37-60


Note: Fig. 2 Shift mechanism housing, removing and installing
- Remove bottom shielding plate and catalytic converter.
- Disconnect selector lever cable from shift mechanism housing.
- Before installing, secure rubber housing -A- to shift mechanism
housing.
- Tighten nut - 9 Nm
Rubber housing -A- must seal shift mechanism housing to chassis
(sealing lip -B-). Do not rout any cables between chassis and mounting bracket.
Pa
ge 65 of 75 Selector lever mechanism, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.37.1