AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual https://www.carmanualsonline.info/img/6/1266/w960_1266-0.png AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual

Page 1 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual 39-10
 
     
Differential, removing and 
installing  
     
Special tools and equipment  
     
VW771 slide hammer - complete set
     3257 Puller 
     Kukko 21/3 extractor
     
Notes:  
     Remov

Page 2 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual Look for visible damage to polygon bearings.
     The rough operation of the polygon bearing with 
the drive flange not installed is not an indication 
that the bearings are malfunctioning. An 
acoust

Page 3 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual 39-11
 
  
1 - 
Transmission housing 1) 
2 - 
Seal 
Always replace   Page 39
-1
3 - 
Circlip 
Always replaceRemoving and installing   Fig. 1
4 - 
Spacer ring 
Only for drive flange with polygon bearin

Page 4 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual 39-12
 
  
7 - 
Cover for final drive 1) 
Coat sealing surfaces with thin layer of 
sealant AMV 188 001 02 
8 - 
Torx  bolt 25 Nm (18 ft lb)
9 - 
Drive gear for Vehicle Speed Sensor (VSS)Removing and

Page 5 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual 39-13
 
    
Fig. 1  Removing and installing circlip
-  Clamp drive flange into vise using protective jaws. Press circlip out of 
groove in drive flange by pressing in new circlip -A-. 
    
Fig. 2  R

Page 6 of 6

AUDI A4 2000 B5 / 1.G 01W Transmission Differential Remove And Install Workshop Manual 39-14
 
    
Fig. 3  Installing spacer ring
-  Press in spacer ring to stop without canting.
    
Note:  
Needle bearings (polygon bearings) do not turn easily with drive flange 
removed. This does no