check engine AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide

[x] Cancel search | Manufacturer: AUDI, Model Year: 2000, Model line: A4, Model: AUDI A4 2000 B5 / 1.G
Pages: 39, PDF Size: 0.16 MB
AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide A4 2000 B5 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1050/w960_1050-0.png AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide
Search: (phone, immobilizer, brake fluid, dimensions, tires, window)

Page 12 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-147 The learning process (adaptation process) is carried out: By selecting "Basic Setting" (function 04), Display Group 060 with the ignition switched on. Automatically if t

Page 13 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-148 Test conditions for adaptation of throttle valve control module No malfunctions stored in DTC memory Page 01 -15 , check DTC memory Engine not running, ignition switc

Page 15 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-150 When the -Q- button is pressed the throttle valve positioner will be switched mechanically. In this condition the throttle valve is pulled into an "emergency running" or defaul

Page 18 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-152 Note: If the adaptation process is interrupted by the control unit, the cause could be one of the following: The throttle valve is unable to close completely (e.g. becau

Page 19 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide start again automatically the next time the ignition is switched on (for several seconds). - End engine basic setting by pressing the button. - Press buttons -0- and -6- to select "

Page 20 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-153 Angle sensor -1- for throttle drive (power accelerator actuation) -G187- and angle sensor -2- for throttle drive (power accelerator actuation) -G188, checking The angle senso

Page 21 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-154 Note: The engine control module converts the voltage readings from the angle sensors into percentages of 5 V and displays them as percentages. (A signal wire voltage of 5 V is equivalent to 1

Page 24 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-157 Checking voltage supply to throttle valve control module - Disconnect harness connector from throttle valve control module. - Switch ignition on. If the specifica

Page 25 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-158 Checking wiring for voltage, signal and activation - Connect VAG1598/31 test box to wiring harness for engine control module. Do not connect to the engine control module itse

Page 26 of 39

AUDI A4 2000 B5 / 1.G APB Engine Electronic Engine Power Control Checking User Guide 24-159 Throttle Position (TP) sensor -G79 and Sender -2- for accelerator pedal position -G185, checking Component location of Throttle Position (TP) sensor -G79 and Sender -2- acceler
Page:   < prev 1-10 11-20 21-30 next >
Search: (engine overheat, ground clearance, reset, width, climate settings, spare tire location)