stop start AUDI A4 2000 B5 / 1.G ATQ Engine Ignition System Checking Workshop Manual

28-20
Component location Overview of Component
Locations, page Page 24
-5

Note:
The engine speed (RPM) sensor detects RPM
and reference marks. The engine cannot be
started without a signal from the engine speed
(RPM) sensor -G28-. If the engine speed (RPM)
sensor -G28- signal fails while the engine is
running, the engine will stop immediately.

Test sequence

- Before performing test, check sensor for proper
installation and proper fitting.

- Disconnect harness connector for the engine
speed (RPM) sensor (identification: gray
harness connector).

Note:
Resistance value of the engine speed (RPM) sensor is based on a
temperature of 20 C. Resistance increases as temperature increases. - Connect multimeter between terminal 2 and 3 for resistance
measurement.

Specification: 730 to 1000
Pa
ge 23 of 65 I
gnition s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.28.1