AUDI A5 2008 8T / 1.G Owners Manual

AUDI A5 2008 8T / 1.G Owners Manual A5 2008 8T / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/861/w960_861-0.png AUDI A5 2008 8T / 1.G Owners Manual

Page 261 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help259
Controls
Safety
Driving tips
General maintenance
Self-help
Technical data
– Check whether a repair is possible using the Tyre 
Mobility System ⇒page 257.
– Ensure that all passenger

Page 262 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help 260•
Seek professional assistance if the repair of a tyre puncture is 
not possible with the sealing compound.
•
If tyre pressure is less than 1.3 bar after driving about 10 
minutes, th

Page 263 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help261
Controls
Safety
Driving tips
General maintenance
Self-help
Technical data
–Loosen the wheel bolts ⇒page 261.
–Raise the car with the jack* ⇒page 262.
–Ta k e  o f f the wheel wi

Page 264 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help 262
Loosening
–Fit the box spanner as far as it will go over the wheel 
bolt
7).
– Grip the box spanner as close to the end as possible and 
turn the wheel bolts about one turn anti-cloc

Page 265 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help263
Controls
Safety
Driving tips
General maintenance
Self-help
Technical data
– Now fit the crank handle   onto the jack by inserting it 
in the opening on the knob ⇒page 262, fig. 244. T

Page 266 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help 264
– Screw in the mounting pin (provided in the vehicles tool 
kit) by hand in place of the wheel bolt ⇒page 263, 
fig. 246.
– Then unscrew the other wheel bolts as described above.

Page 267 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help265
Controls
Safety
Driving tips
General maintenance
Self-help
Technical data
– Insert the hook (provided in the vehicles tool kit) in the 
hole in the hub cap.
–Pull off the hub cap ⇒

Page 268 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help 266Starting the engine
The two jump leads must be connected in the correct 
sequence.The jump-start terminals are located in the engine compart-
ment ⇒fig. 248.
Connecting the positive ter

Page 269 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help267
Controls
Safety
Driving tips
General maintenance
Self-help
Technical data terminal must not touch metal parts of the vehicle: this can cause 
short circuiting.
•
Do not bend over the ba

Page 270 of 313

AUDI A5 2008 8T / 1.G Owners Manual Self-help 268Do not pull too hard with the towing vehicle and take care to avoid 
jerking the towrope. When towing on a loose surface there is always 
a risk of overloading and damaging the anchorage