tow AUDI A6 1995 C5 / 2.G 01E Transmission Shift Control Mechanism Workshop Manual

34-5

Selector mechanism, removing and
installing


Removing

- Unscrew shift knob from shift lever.

Note:
Shift cover is removed together with the cover for
center console.

- Slightly lift off cover for center console upward (arrows -A-).
- Pull cover slightly toward back (arrow -B-), then lift complete cover
upward.
Pa
ge 5 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.1

34-7


Repair Manual, 2.7 Liter V6 5V BiTurbo Engine Mechanical, Engine
Code(s): APB, Repair Group 26
- Remove heat shield for left-hand inner joint -1- from transmission
(arrows).
- Disconnect left-hand drive axle -1-, lift toward front and tie up.
- Remove rear section of exhaust system (rearward of exhaust pipe
clamp(s)):
- Remove heat shield above driveshaft.

- Remove heat shield for driveshaft from cover for Torsen differential
(arrows).
- Remove driveshaft Page 39
-68
.
Pa
ge 7 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.1

34-14


- Loosen bolt for selector rod (arrow).
Connection between selector rod and selector mechanism should
move freely.
- Adjust gear shift as follows:

Note:
The illustration shows the gear shift from behind (looking towards the front
of the vehicle).
Gear shift vertical, maximum inclination of 3 to the right (angle )
Pa
ge 14 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.1