coolant reservoir AUDI A6 1995 C5 / 2.G ATQ Engine Oxygen Sensor Control Checking

24-89

Checking primary voltage
Component location of harness connectors
Overview of component locations, page Page
24
-5

Note:
Coolant reservoir screws must be removed and
coolant reservoir must be placed to side in order
to access this harness connector. The coolant
hoses can remain connected.

Test requirement:

Fuse for oxygen sensor are OK

- Disconnect 4-pin harness connector leading to
respective oxygen sensor.

If specified value is not obtained: - Connect multimeter between terminal 3 and 4 for voltage
measurement.
- Switch ignition on.

Specification: 0.400 to 0.500 V
- Switch ignition off.
-
Check oxygen sensor wires Bank 1, page Page 24
-90
or Bank Pa
ge 15 of 63 Ox
yg
en sensor control, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.24.3