AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual https://www.carmanualsonline.info/img/6/1306/w960_1306-0.png AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual

Page 1 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-64
 
     
Driveshaft, servicing 
     
Note:  
     
Observe general repair instructions   Page 00
-
11
 . 
     
Do not bend the driveshaft more than 25 at the 
central joint, otherwise the unive

Page 2 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual is essential to check whether correct 
adjustment of the driveshaft rectifies the fault 
before replacing the driveshaft. 
     After removing the driveshaft from the rear final 
drive, the additional

Page 3 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-65
 
  
1 - 
Rear final drive 
2 - 
Gasket 
Always replacePull off backing foil, and stick self-adhesive 
side of gasket to drive flange. Remove grease from drive flange
3 - 
Constant velocity join

Page 4 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-66
 
  
6 - 
Universal joint 
Maximum permissible angle of deflection 
25  
7 - 
Shim 
Determining thickness   Page 39
-76
8 - 
Hex bolt, 23 Nm 
9 - 
Driveshaft center mounting 
10 - 
Driveshaft 
A

Page 5 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-67
 
  
12 - 
Lock plate 
13 - 
Constant velocity joint 
Maximum permissible angle of deflection 
8 
14 - 
Gasket 
Always replacePull off backing foil, and stick self-adhesive 
side of gasket to dr

Page 6 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-68
      
Driveshaft, removing and installing
 
     
Special tools, testers and auxiliary items  
     
Assembly appliance 3405
     
- Observe notes   Page 39
-64
 .
     
Removing  
     
-  If

Page 7 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-69
      
Removing  
     
-  Remove heat shields above driveshaft.
    
-  Remove heat shield for driveshaft from cover for Torsen differential 
(arrows). 
    
Note:  
Only mark if the same drive

Page 8 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-70
      
-  Loosen securing bolts on both driveshaft 
flanges. 
     
-  Unscrew three upper securing bolts on each 
driveshaft constant velocity joint. 
     
-  Loosen securing bolts of center d

Page 9 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual 39-71
      
Installing  
      Installation is carried out in the reverse order, 
when doing this note the following:  
     
Note:  
     
It is essential that the locking fluid remaining in 
the th

Page 10 of 19

AUDI A6 1997 C5 / 2.G 01E Transmission Final Driveshaft Service Workshop Manual the flange. After removing the driveshaft from the rear final drive, the additional 
balance disk (thick washer) that may be located between the lock 
plate and the bolt head must not be reinstalled.
Page:   1-10 11-20 next >