light AUDI A6 1998 C5 / 2.G 01E Transmission Final Drive Rear Remove And Install Workshop Manual

39-106


Note: - Raise final drive with transmission jack until both drive axles can be
connected.
- Lightly tighten securing bolts for drive axles.
- Lift final drive and bolt to cross member and final drive support.
- Bolt on driveshaft Page 39
-71
.

To prevent imbalance, the flanges on the driveshaft -A- and on the
rear final drive -B- must be installed so that the paint markings are in
alignment (arrows). After removing the driveshaft from the rear final drive, the additional
balance disk (thick washer) that may be located between the lock
plate and the bolt head must not be reinstalled. Always replace all
flange bolts after disassembling. Replace driveshaft bolts (self-locking).
Pa
ge 5 of 8 Rear final drive, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.14