wiring AUDI A6 1999 C5 / 2.G 01E Transmission Clutch Mechanism Service Workshop Manual

30-17

Master cylinder, removing and installing


Special tools, testers and auxiliary items

Removing
Remove E-Box from plenum chamber as follows:
Hose clamp 3094
- If installed, remove cover above plenum chamber.
- Disconnect battery Ground (GND) strap with the ignition switched off.

Repair Manual, Electrical Equipment, Repair Group 97
- Pull off clip -1- and lift wind grill -A- slightly. Now remove screw (arrow -
2-).
- Remove remaining screws (arrows) and remove cover.
- Remove engine control unit and 8-point relay carrier (if fitted)
- Unplug connector in connector station.
- Pull engine wiring harness together with rubber grommet out through
opening in electronics box.
Pa
ge 17 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1

30-24

- Remove driver's side storage compartment:

Repair Manual, Body Interior, Repair Group
68


Repair Manual, Electrical Equipment, Repair Group 97
- Always replace seal -C-.
- Make sure seal does not cover chassis opening and elevated edge of
sheet metal.
- Insert E-Box in securing point -B- and tighten nuts -A- to 4 Nm.
- Press cover on by hand and tighten bolts -A- diagonally to 4 Nm (also
see inscription on cover).
- Install engine wiring harness and connect harness connector in
connector station.
- Install engine control module and if necessary, auxiliary relay carrier
and auxiliary fuse holder.
Pa
ge 24 of 27 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.1