coolant AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide

[x] Cancel search | Manufacturer: AUDI, Model Year: 1999, Model line: A6, Model: AUDI A6 1999 C5 / 2.G
Pages: 34, PDF Size: 0.54 MB
AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide A6 1999 C5 / 2.G AUDI AUDI https://www.carmanualsonline.info/img/6/946/w960_946-0.png AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide
Search: (oil type, traction control, gearbox, drain bolt, dashboard, park assist)

Page 11 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-10 - Start engine and maintain an engine speed of about 2000 RPM for approx. 3 minutes. - Allow engine to idle until the lower radiator hose is hot.Check coolant level and top up

Page 12 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-11 Coolant pump and coolant thermostat, servicing 1 - Bolt M6: 10 Nm (7 ft lb)M8: 20 Nm (15 ft lb) 2 - Lower toothed belt cover Removing and installing Page 13 -29 3 - Nut 10 Nm (7 f

Page 13 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-12 7 - T-head bolt Insert before installation 8 - Coolant thermostat Removing and installing Page 19 -20 Checking Page 19 -20 9 - Connector 10 - Drain plug 30 Nm (22 ft lb) 11 - O-r

Page 14 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-13 Coolant pump, removing and installing Note: Coolant pump is bolted to bracket for generator, power steering pump and viscous fan. Lock carrier in service position

Page 16 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-14 - Drain coolant Page 19 -4 . - Loosen clamps for coolant hoses -1- and -2-. - Remove coolant hose to radiator at coolant line. - Remove intake air duct between intake manifold a

Page 17 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-15 Note: Power steering pump remains installed. - Pull off coolant hoses from coolant pump and coolant thermostat housing. - Unbolt coolant pump housing from toothed b

Page 18 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-16 Installing Installation is the reverse of removal, noting the following: - Clean sealing surfaces of both housings. - Replace gasket and O-ring. - Insert T

Page 19 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-17 Note: When installing ribbed belt, check for correct seating on belt pulley. - Install V-belt Page 13 -18 . - Fill up with coolant Page 19 -6 . WARNING!

Page 23 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-19 Component Tightening torques Generator to bracket for generator, power steering pump and viscous fan M8 25 Nm (18 ft lb) M10 40 Nm (30 ft lb) Belt pulley to coolant p

Page 24 of 34

AUDI A6 1999 C5 / 2.G AEB ATW Engines Cooling System Components User Guide 19-20 Coolant thermostat, removing, installing and checking Removing - Drain coolant Page 19 -4 . Installing WARNING! The cooling system is pressurized when the engin
Page:   < prev 1-10 11-20 21-30 next >
Search: (engine, radio antenna, four wheel drive, adding oil, carplay, service schedule)