AUDI A6 1999 C5 / 2.G AHA ATQ Engines Assembly Workshop Manual

13-1


Engine, disassembling and
assembling Lock carrier, moving into service position

Special tools and equipment
3369 support tool
1 -
Bolts
45 Nm (33 ft lb)
2 -
Bolts 45 Nm (33 ft lb)
3 -
Bolts 10 Nm (7 ft lb)
4 -
Bolts 10 Nm (7 ft lb)
5 -
Bore For 3369 support tool
6 -
Lock carrier bore
7 -
Fender bore
Pa
ge 1 of 3 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.1

13-2


Repair Manual, Body Exterior, Repair Group 63
- Remove front bumper.
- Remove 3 quick-release screws on front of noise
insulation panel.
- Unbolt air guide between lock carrier and air
cleaner at lock carrier.
- If installed, remove retaining clamps for wiring
harness on left side of radiator frame.
- Remove bolt -2- and install 3369 support tool.
- Install 3369 support tool into left bore -5-.
- Remove bolts -1- and -3-.
- Remove bolts -4- and pull lock carrier out to
stop.
- To secure lock carrier, install appropriate M6
bolts into rear bored holes of lock carrier -6- and
fender -7-.
Pa
ge 2 of 3 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.1

13-3


Repair Manual, Body Exterior, Repair Group 63
- After installing lock carrier, check wiring for
proper routing near coolant fan.
- Install front bumper.
Pa
ge 3 of 3 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.13.1