AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual A8 1996 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1207/w960_1207-0.png AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owner's Manual

Page 21 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-91
 
    
For 6 cylinder TDI engines 
Item A = bushings  
    
Use 3282/19 adjustment plate to position the 3282 transmission support 
for Automatic Transmission 01V.  
The symbols on the adjustmen

Page 22 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-92
      
-  Place transmission onto transmission support.
    
-  Secure transmission on 3282 transmission support using bolt -A-.
-  Move transmission into position between the lowered subframe a

Page 23 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-93
      
Note:  
     
If installed, place intermediate plate onto 
bushings. 
     Make sure that wires do not get pinched as 
transmission is docked at engine. 
      Check whether the torque co

Page 24 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-94
      
For 6 cylinder TDI engines 
    
Continuation for all vehicles 
Note:  
Some bolts also have a bracket or a Ground (GND) connection attached 
 refer to tightening torque tables starting

Page 25 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-95
      
-  Only perform vehicle alignment if necessary.
     
       Repair Manual, Suspension, Wheels, 
Steering, Repair Group 44; Vehicle alignment
   
     
-  Install transmission supports at

Page 26 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-96
       For vehicles with Torx bolts:  
    
 Repair Manual, Electrical Equipment, Repair Group 27; Starter, 
removing and installing
    -  Bolt 3 torque converter bolts to drive plate using res

Page 27 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-97
 
    
-  Bolt in bolts at mounting bracket of selector lever cable, install selector 
lever cable and if necessary, adjust. 
    
All-wheel-drive vehicles   -  Connect connector of multi-functi

Page 28 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-98
 
    
Continuation for all vehicles 
 Radio operating manual   
Tightening torque table   Page 37
-119
 onward.   -  Bolt heat shield -B- for driveshaft to Torsen differential cover (arrows) if

Page 29 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-99
      
Removing and installing for 2.7 Liter 5V turbo 
engine:  
    
-  Remove bolts (arrows) and remove engine covers -A- and -B-.
-  Remove cover above air filter.
    
-  Remove coolant expa

Page 30 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install Owners Manual 37-100
 
    
-  Remove air distributor (arrows).
    
-  Remove heat sensor -1- from right turbocharger using 3035.
-  Remove heat shields -2- from left and right turbochargers.
-  Remove upper bolts