AUDI A8 1996 D2 / 1.G AHA ATQ Engines Lubrication System Components Checking Manual

17-30


Lubrication system
components, checking

Oil pressure and oil pressure switch,
checking


Note:
For the functional check and servicing of the
optical and acoustic oil pressure warning
"Electrical Wiring Diagrams, Troubleshooting
&Component Locations".

Test sequence

- Remove oil pressure switch -F1- and install in tester.
- Install tester into oil pan in place of oil pressure switch.
- Connect brown wire of tester to Ground (GND).
- Using auxiliary cables from VW1594, connect VAG1527B voltage
tester to oil pressure switch and Battery (+).
- Start engine and slowly increase engine speed (RPM).
At 1.2-1.6 bar pressure LED must light up.
- If not, replace oil pressure switch.
- Increase engine speed (RPM) further.
-
At 2000 rpm and an oil temperature of 80 C, oil pressure must be at
least 2.0 bar.
Pa
ge 1 of 3 Lubrication s
ystem com
ponents, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.2

17-31

Engine oil

Engine oil capacity (w/filter): 5.7 L (6.0 qt.).
The engine is factory-filled with a high quality
multi-grade oil that can be used as an all-season
oil, except in extremely cold climates.

Viscosity classes and oil specifications

Select the viscosity according to the chart shown. The oil does not need
to be changed if the outside temperature only briefly exceeds the
specified ranges.
The specifications stated on these pages must be indicated on the
container either individually or in combination with other specifications. 1) This VW specification must have a date of 10/91 or later. 2) These oils may only be used in exceptional cases if no approved
engine oil is available.
Mixing oils when topping up is permissible. A - Multi-grade oil, specification VW 500 00
1)
B - Multi-grade oil, specification VW 501 01
1)

Multi-grade oil, specification API-SF- or -SG-
2)
Pa
ge 2 of 3 Lubrication s
ystem com
ponents, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.2

17-32

Oil level, checking


Test requirements

Minimum engine oil temperature 60 C

Vehicle must be standing on level ground
when checking oil level
After stopping engine, wait a few minutes to
allow oil to flow back into oil pan

- Withdraw dipstick, wipe using clean cloth and
reinsert fully.

- Withdraw dipstick again and read oil level.

Range of markings on dip stick:
CAUTION!
Do not overfill with oil past the MAX mark on the oil dipstick.
Damage to the Three Way Catalytic Converter (TWC) could result. a - Oil MUST NOT be topped off.
b - Oil may be topped off. After topping off, oil may reach range -a-.
c - Oil MUST BE topped off. After topping off, it is sufficient if oil level is
somewhere in range -b- (shaded area).
Pa
ge 3 of 3 Lubrication s
ystem com
ponents, checkin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE03.17.2