AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual A8 1997 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1207/w960_1207-0.png AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual
Trending: ECU, automatic transmission, engine, wheel, radio, steering wheel adjustment, engine coolant

Page 41 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-111
 
  
-  Remove bolt -9- with bracket -12-.
-  Disconnect ATF lines at bolts -10- and -11- and 
plug the lines with clean plugs. 
-  Loosen nut -3- with bracket -4- in order to 
prevent tension

Page 42 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-112
      
-  Remove remaining connection bolts for 
engine/transmission. 
     
-  Press transmission off engine, while pressing 
torque converter out of drive plate. 
    
-  Press torque convert

Page 43 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-113
      
Installing  
     
Installation of transmission is the reverse of 
removal. The following points must also be 
observed: 
      Before installing:  
     
-  Clean threads in driveshaft

Page 44 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-114
 
    
Use 3282/19 adjustment plate to position the 3282 transmission support 
for Automatic Transmission 01V.  
The symbols on the adjustment plate indicate the necessary mounts and 
the arrow

Page 45 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-115
 
    
Note:   -  Press the lever/shift rod -2- at transmission completely toward rear 
(toward right in illustration) until park lock is engaged. 
-  Shift selector lever into "P" and carefull

Page 46 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-116
      
WARNING! 
     
In case of an incorrectly inserted torque 
converter, the coupling plate of the torque 
converter or the ATF-pump will be destroyed, 
if the transmission is flanged to th

Page 47 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-117
 
    
 Repair Manual, Suspension, Wheels, Steering, Repair Group 40; 
Subframe, removing and installing
   
 Repair Manual, Suspension, Wheels, Steering, Repair Group 44, 
Vehicle alignment

Page 48 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-118
      
-  Bolt drive axles to transmission flanges.
     
       Repair Manual, Suspension, Wheels, 
Steering, Repair Group 40
   
     
-  Bolt driveshaft to transmission flange   page 
39
-79

Page 49 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual -  Then activate all power window switches ("up") 
for at least one second to activate automatic 
window raising/lowering. 
     
-  Set clock to correct time.
Pa
ge 49 of 64 Transmission, removin
g a

Page 50 of 64

AUDI A8 1997 D2 / 1.G 01V Transmission Remove And Install Service Manual 37-119
      
Tightening torques
 
     
Notes:  
     
Tightening torques are valid only for nuts and 
bolts that are lightly greased, oiled, covered 
with a thin coat of phosphate or blackened.
Trending: sensor, steering wheel adjustment, wheel, ECU, engine coolant, radio, engine