AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual A8 1999 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1213/w960_1213-0.png AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual

Page 1 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-95
 
  
Torque tube, removing and 
installing Assembly overview
 
1 - 
Bolt - 40 Nm 
2 - 
Front crossmember 
3 - 
Bolt - 40 Nm 
4 - 
Transmission support 
5 - 
Torque tube 
6 - 
Rear final drive ho

Page 2 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-96
 
  
Removing
 
Special tools and equipment    
Rear final drive installed 
 VW 771 slide hammer-complete set with 771/15 
threaded piece 
 VAG1306 drip tray
 Engine/transmission jack VAG1383A

Page 3 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-97
      
-  Place VAG1306 drip tray underneath and drain 
gear oil. 
     
-  Remove rear part of exhaust system behind 
clamping sleeve(s): 
     
       Repair Manual, Engine Mechanical, Repair

Page 4 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-98
 
    
Note:  
If the driveshaft cannot be pressed upward past the flange, tie up 
driveshaft after lowering final drive. When lowering, secure driveshaft 
against falling down and note permissi

Page 5 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-99
      
-  Lower final drive approx. 10 cm.
    
Note:  
The 4. bolt is not visible in the illustration.  -  Remove 4 bolts for torque tube 1 to 3.
    
-  Pull off flange shaft with torque tube.

Page 6 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-100
      
Installing
 
      Installation is reverse of removal, noting the 
following:  
     
Notes:  
     
After removing driveshaft, always remove any 
remaining locking fluid from thread hol

Page 7 of 7

AUDI A8 1999 D2 / 1.G 01V Transmission Torque Tube Remove And Install Workshop Manual 39-101
      
-  Install exhaust system free of stress:
     
       Repair Manual, Engine Mechanical, Repair 
Group 26; removing and installing exhaust 
system        
-  Top-up and check gear oil in