warning AUDI A8 2000 D2 / 1.G 01V Transmission Drive Shaft Service Workshop Manual

39-74

Specific notes for carbon fiber driveshafts:

WARNING!

Driveshaft made of carbon fiber

do not impact / do not hi
t

do not drop

If the surface is damaged, driveshaft must be
replaced

Do not bend the driveshaft, maximum
permissible bending angle is 25 . Otherwise
the universal joint may be damaged.

Only store and move driveshaft fully
extended.
Pa
ge 2 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5

39-81

- Remove mounting bolts for both driveshaft
flanges.

- Remove upper three mounting bolts for each
driveshaft constant velocity joint.

- Back off mounting bolts for center support
slightly.

Only for carbon fiber driveshafts:

Spacer pieces are attached to 3405 alignment fixture via a chain.
Arrow -A- points in direction of travel.
WARNING!
Assembly tool must rest on both steel rings -1- before tightening
plastic nut -A-. If that is not the case, the surface of the carbon fiber
driveshaft can be damaged and must be replaced see Important
notes Page 39
-74
- Place spacer pieces -2- onto 3405 alignment fixture (distance
dimension = 10 mm).
- Using spacer pieces -2-, hook in 3405 alignment fixture according to
illustration.
Pa
ge 10 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5

39-89

Only for carbon fiber driveshafts:

Spacer pieces are attached to 3405 alignment fixture via a chain.
Arrow -A- points in direction of travel.
WARNING!
Assembly tool must rest on both steel rings -1- before tightening
plastic nut -A-. If that is not the case, the surface of the carbon fiber
driveshaft can be damaged and must be replaced see Important
notes page 39
-74
- Place spacer pieces -2- onto 3405 alignment fixture (distance
dimension = 10 mm).
- Using spacer pieces -2-, hook in 3405 alignment fixture according to
illustration.

Note:
Never set alignment fixture on balance plates. - Carefully tighten plastic nuts -A- and -B-.
Pa
ge 19 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5