transmission AUDI A8 2000 D2 / 1.G 01V Transmission Electrical Testing Workshop Manual

01-274

Additional information

Repair Manual, 5 Spd. Automatic Transmission
01V,
Electrical Wiring Diagrams, Troubleshooting &
Component Locations"

Notes:
Use VAG1526A multimeter for the test. The
tables list which measures range needs to be
selected before taking each measurement.
The specified values are valid for an ambient
temperature of 0 to 40 C (32 to 104 F).

If the values obtained differ from the specified
values, determine the malfunction using the
applicable wiring diagram.
If the measured values only deviate slightly
from the specified values clean sockets and
connectors of testers and repeat test. Before
replacing a component, check wires and
connections. If the specified values are below
10 , repeat the resistance measurement on
the component.
Pa
ge 2 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-275

The contact numbers of the connector and the
socket numbers of VAG 1598/20 test box match
up page 01
-277
.

To check the multi-function switch, it is not
necessary to connect test box VAG 1598/20
because first the connectors for the multi-
function switch are checked.

CAUTION!

To avoid permanent damage of electronic
components, select the appropriate
measuring range on tester before connecting
the measuring leads.

Test requirements
Battery voltage OK
Fuses for Transmission Control Module
(TCM) OK

Electrical Wiring Diagrams, Troubleshooting &
Component Locations

Fuses for component being tested OK. The
fuse holder is behind a cover on the side of
Pa
ge 4 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

the instrument cluster.
Ground (GND) connections OK:

Check battery Ground (GND) strap and Ground
(GND) strap between body and transmission.

Check Ground (GND) connections for
Transmission Control Module (TCM).

Electrical Wiring Diagrams, Troubleshooting &
Component Locations
Pa
ge 5 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-276


- For all test steps, switch ignition off, disconnect multi-pin connector for
Transmission Control Module (TCM) -J217- (located in front of
passenger seat under carpet in foot well page 01
-11
) and connect
VAG1598/20 adapter to wiring harness connector.
- If measuring values do not match specifications, follow instructions in
right-hand column of test table (labelled "Corrective action") page
01
-11
.
- Always perform all steps indicated in the "Corrective action" column.
- Only perform test steps recommended in the DTC table (selective
troubleshooting).
Pa
ge 6 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-277
88-pin connector for Transmission Control Module (TCM) -J217- (sockets on VAG1598/20)
1- Solenoid valve 5 -N92- 18-
Kick-down switch -F8- (not for E-gas and V6-TDI)
2- Shift lock solenoid -N110- 19-
Control input to transmission from ABS control module
3- Vacant 20-
Engine intervention (via ignition timing)
1)
4- Solenoid valve 7 -N94- 21-
ATF temperature sensor -G93-
5- Solenoid valve 4 -N91- 22-
ATF temperature sensor -G93-
6- Ground (GND) for power consumers, term.
31 23-
Sensor for transmission RPM -G182- (shielding)
7- Vacant 24-
Vacant
8- Multi-function TR switch -F125-, L2 25-
Selector lever display (not for Highline combi)
9- Multi-function TR switch -F125-, L4
supply voltage for cruise control system 26-
Supply voltage (terminal 30) with or without fuses depending on
model wiring diagram
10-
Brake light switch -F- (not for E-gas and
V6-TDI) 27-
Kick-down for air conditioning
1)
11-
Vacant 28-
Ground (GND) for electronics (terminal 31)
4)
12- Vacant 29- Solenoid valve 6 -N93-
Pa
ge 7 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

13-
Tiptronic recognition 30-
Solenoid valve 1 -N88-
14-
Transmission VSS -G38- 31-
Vacant
15-
Transmission VSS -G38- (shielding) 32-
Solenoid valve 3 -N90-
16-
Sensor for transmission RPM -G182- 33-
Solenoid valve 2 -N89-
17-
Signal for malfunction monitor (OBD II -
request)
1) 2) 34-
Ground (GND) for power consumers (terminal 31)
Pa
ge 8 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-278

35- Fuel consumption signal
(engine torque, actual)
1) 54- Supply voltage (terminal 15)
36- Multi-function TR switch -F125-, L1 55- Supply voltage (terminal 15)
37- Multi-function TR switch -F125-, L3 56- Vacant
38- Vacant -
39- Vacant -
40-
Engine speed (RPM) signal
1)
-
41-
Throttle position value (load signal)
1)
-
42- Transmission VSS -G38- -
43- Vacant -
44- Sensor for transmission RPM -G182- - Terminals 57 - 83 are vacant
45- Vacant -
46- Tiptronic upshift switch -
47- Tiptronic downshift switch -
48- Vacant -
49- Vacant 84- Vacant
50- Vacant 85-
CAN-bus
3)
51- Upshift/downshift signal
(for engine torque reduction) 86-
CAN-bus 3)
Pa
ge 9 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-279
1) Only for vehicles without a CAN-bus.

Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00; Code letters, engine/transmission applications, ratios, equipment

2) Signal is transmitted to Transmission Control Module (TCM) via the Engine Control Module (ECM) and can only be checked
in read measured value block page 01
-186
.
3) Only for vehicles with a CAN-bus. Further information for CAN-BUS on the CAN-bus page 01
-263


Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00; Code letters, engine/transmission applications, ratios, equipment

4) Pin 28 at the control module is vacant for vehicles with 10-pin connector of multi-function switch -F125-.
Pa
ge 11 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-280
List of test steps (88-pin connector)

Only perform test steps for the relevant component, as listed in DTC and Read Measuring Value Block tables.
Item checked
Item checked
Supply voltage for TCM -J217-
- Perform test
steps 1 and 7 Solenoid valve 5 -N92- (Pressure control
valve -2- -N216-) - Perform test steps 13
and 8
Shift lock solenoid -N110-
- Perform steps 2,
6 and 16 Solenoid valve 6 -N93- (pressure control
valve -3- -N217-) - Perform test steps 14
and 8.
Brake light switch -F-
- Perform test
step 3. Solenoid valve 7 -N94- (pressure control
valve -4- -N218-) - Perform test steps 15
and 8.
Supply voltage for cruise
control system - Perform test
step 4. Transmission VSS -G38- (Sensor for
transmission output RPM -G195-) - Perform test step 18.
Kick-down switch -F8-
(not for E-gas) - Perform test
steps 5 and 17 Sensor for transmission RPM -G182-
- Perform test step 19.
Multi-function TR switch
(driving range sensor) -F125- - page 01
-322
ATF temperature sensor -G93-
- Perform test step 20.
Solenoid valve 1 -N88-
- Perform test
steps 8 and 9 Wiring connection to ECM
1)
- Perform test steps 21,
22, 23, 24, and 25
1) Signal is transmitted to Transmission Control Module (TCM) via the Engine Control Module (ECM). Test is only for vehicles
without CAN-bus.
Pa
ge 12 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16

01-281

Item checked
Item checked
Solenoid valve 2 -N89-
- Perform test steps
10 and 8 Tiptronic switch -
F189- - Perform test steps 26 and 27
Solenoid valve 3 -N90-
- Perform test steps
11 and 8 CAN-bus
2)
- Perform test step 28 and check CAN-bus
system page 01
-265
.
Solenoid valve 4 -N91-
(Pressure control valve -1-
-N215-) - Perform test steps
12 and 8 2) Only for vehicles with CAN-bus

Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00; Code letters, engine/transmission applications, ratios, equipment


Repair Manual, 5 Spd. Automatic Transmission 01V, Repair Group 00; Code letters, engine/transmission applications, ratios, equipment

Pa
ge 13 of 66 Electrical testin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT02.01.16