jack points AUDI S3 2009 Owners Manual

llffl.,___W_ h_ a _ t_d_ o_ l _d _o_ n_ o_ vv_ ? ______________________________________________ _
Loosening and tightening the wheel bolts
The wheel bolts must be loosened before raising the
vehicle.
~ a'.. ., m
Loosening
Fig . 194 Wheel
change: loosening the
wheel bolts
-Fit the wheel bolt wrench over the wheel bolt and push it
down as far as it will go .
- Close your grip around the
end of the wrench handle for
maximum torque and turn the wheel bolts
counter-clock­
wise
about one single turn in the direction of arrow
~ fig. 194.
Tightening
- Fit the wheel bolt wrench over the wheel bolt and push it
down as far as it will go.
- Close your grip around the
end of the wrench handle for
maximum torque and turn each wheel bolt
clockwise
until it sits tight.
& WARNING
• Using force without control to speed the wheel change up can
cause the vehicle to slip off the jack and cause serious personal
injuries.
• Do not loosen the wheel bolts more than one turn before you
raise the vehicle with the jack. -Risk of injury!
[ i ] Tips
• Never try and use the hexagonal socket in the handle of the
screwdriver to loosen or tighten the wheel bolts.
• If a wheel bolt sits very tight, you may find it easier to loosen by
carefully pushing down on the end of the wheel bolt wrench with
one foot only . As you do, hold on to the car to keep yourself stable
and take care not to slip. •
Raising the vehicle
The vehicle must be lifted with the jack first before the
wheel can be removed.
Fig . 195 Wheel
change: mounting
points
for the lifting
jack ..

________________________________________________ E_ m_ e_r .::g :...e_ n _ c_,y'-- s_ i_t _u _a_ t_ i_o _n_ s _---JIIII
Lifting the vehicle
Important safety precautions
Be aware of the following hazards before lifting the vehicle with a
workshop hoist or floor jack:
• The vehicle should never be lifted or jacked up from underneath
the engine oil pan, the transmission housing, the front or rear axle
or the body side members. This could lead to serious damage.
• Use lifting equipment with padded contact surfaces to avoid
damage to the underbody or chassis frame.
• Alternatively, cover the contact surfaces on workshop hoist or
floor jack with rubber pads before lifting .
• Before driving over a workshop hoist, check that the vehicle
weight does not exceed the permissible lifting capacity of the hoist .
• Before driving over a workshop hoist, ensure that there is suffi­
cient clearance between the hoist and low parts of the vehicle .
& WARNING
To reduce the risk of serious injury and vehicle damage:
• Always lift the vehicle only at the special workshop hoist and
floor jack lift points illustrated=> fig. 211 and=> fig. 212 .
• Failure to lift the vehicle at these points could cause the vehicle
to tilt or fall from a lift if there is a change in vehicle weight distri­
bution and balance. This might happen, for example, when heavy
components such as the engine block or transmission are
removed .
• When removing such heavy components, anchor vehicle to
hoist or add corresponding weights to maintain the center of
gravity . Otherwise , the vehicle might tilt or slip off the hoist,
causing serious personal injury. •
Lifting with workshop hoist and with floor
jack
The vehicle may only be lifted at the lifting points illus­
trated.
.... L===========::::==:: ~ 0:. (D
Fig . 211 Front lifting
point
Fig . 212 Rear lifting
point
Read and heed WARNING~ & in "Important safety
precautions ".
Locate lifting points~ fig. 211
~ fig. 212.
Adjust lift ing arms of workshop hoist or floor jack to
match vehicle lifting points.
Inse rt a rubber pad between the floor jack/workshop
hoist and the lifting points.
Vehicle care Do-it-yourself service irechnical data

11111.___E_ m _ e _r-==g :...e_ n_ c...:y _ s_ i_t _u _a _t_ i_o _n_ s _______________________________________________ _
If you mu st lift your veh icle with a floor jack to work underneath , be
sure the vehicle is safely supported on stands intended for this
purpose .
Front lifting point
T he lifting point is located on the floor pan reinforcement about at
t he same leve l as t he jac k mou nti ng poi nt=>
pag e 295, fig. 2 11. Do
not lift the vehicle at the vertical sill reinforcement .
Rear lifting point
T he lifting point is located on the vertical reinforcement of the lower
sill for the o n board jack=>
page 295, fi g. 212 .
Lifting with vehicle jack
Refe r to=> page 276.
0 Note
• Be aware of the fo llo wi ng po ints before l ifting t he ve hicle :
- The vehicle should never be lifted or jacked up from under ­
neath the engine oil pan , the transmission housing , the front or
rear axle or the body side members . This could lead to serious
damage.
- To avoid damage to the underbody or chassis frame , a rubber
pad must be inserted between the floor jack and the lift points .
- Before driving over a workshop hoist, check that the vehi cle
weight does not exceed the permissible lifting capacity of the
hoist .
- Before driving over a workshop hoist , ensure that there is
sufficient clearance between the hoist and low parts of the
vehicle. •

___ A_l.:,. p _h_ a_ b_e _t _ic _ a_l _in _ d_e _x ____________________________________________ _
I
Ignition key 108
Ignition lock ...... ...... .... ...... . 108
Ignition lock posit ions ............... 108
Immobilizer .. .... .... ....... .... .... 10
Important things to do before driving . . 127
Im properly worn safety belts . . . . . . . . . 145
Indicator light
Airbag system . . . . . . . . . . . . . . . 158 , 159
Audi magnetic ride ................ 12
PASSENGER AIR BAG OFF ......... 159
Indicator lights ........... ...... ... 8, 11
Red symbols in the center display . .. 28
Ye llow symbols in the center display . 29
lnfantseats . ........... .... .... .... 174
How do I properly install an infant seat in
my vehicle? .................... 174
Safety instructions ............... 174
Inside rear view mirror .... ... .... ..... 69
Inspection interval ................... 20
Installing child safety seats Safety belts . . . . . . . . . . . . . . . . . . . . . 179
Instrument pane l
I llum ination ........ ... .. .... .... . 57
Instrument pane l and controls .......... 8
Instruments and controls General illustration ........... .... .. 7
Interior light
Rear ................. ........ ... 61
Interior lights ....... ........... .... . 60
Ambient lighting .................. 61
Luggage compartment ............. 62
J
Jack and tools ...................... 270
Jump start location Jump starting (6 -cyl. engine) ....... 290
Jump starting 4-cylinder engine ...... .... .... ... 289
6 -cylinder -engine .... .... ... .. ... 290
Jumper cables .... .... .... .... .... .. 289
Jump -starting 287
K
Key ......... ............ .... ... .... 35
Battery replacement . . . . . . . . . . . . . . . 37
Coded settings .................. 105
Convenience opening and closing of
windows .......... ...... .... ... 47
Key replacement . . . . . . . . . . . . . . . . . . 35
Master key . . . . . . . . . . . . . . . . . . . . . . . 35
Valet key . . . . . . . . . . . . . . . . . . . . . . . . . 35
Key-coded settings Climate controls ...... .... ..... .. 105
Kick-down Automatic transmission 122
L
LATCH 184
Description .......... .......... .. 184
Installing a child restraint ...... ... 185
Location . . . . . . . . . . . . . . . . . . . . . . . . 184
Mounting and releasing the anchorage
hook ...... ............... ..... 186 Launch
Control Program ...... .... ... 122
Leather ...... .... .... .... ...... ... . 214
Cleaning ..................... ... 215
Leaving-home-function .... ... .... .... 56
Lifting jack ... .... .... .... ... .... ... 276
Lifting points ... .. .... .... .... .... .. 295
Lifting/raising the vehicle . ... ... .... . 295
Light sensor package
Automatic headlight control ........ 53
Light/rain sensor defective .. ...... .... 34
Lights Bi-Xenon headlights ....... .... .... 58
Coming-home/ leaving-home-function 56
Emergency flasher .... ........ .... 58
Front fog lights ................... 56
Headlights .... .... ....... .... .... 52
High beam ..... .. .... .... ..... 52, 59
High beam warning/indicator light .. . 14
Instrument panel illumination . ...... 57
Side marker lights ...... ........... 52
Turn signals . ...... .... ...... ... .. 59
Loading the luggage compartment .... 133
Loading the roof rack . ............ .... 9 1
Locking Manual back-up .. ............. .... 44
Power locking switch ...... .... .... 41
Rear lid ..... ...... .... ........... 42
Remote control ................... 39
Using the fold -out key ............. 40
Lower anchorage locator button ...... 184
Lower universal anchorage bars (Canada) ...
184
Lower universal anchorages (Canada) .. 184