torque AUDI S4 1997 B5 / 1.G 01E Transmission Shift Control Mechanism Workshop Manual

34-11


Tightening torques Component

Nm
Hex bolt -1- 75
Combi bolt -2-
110 + 90 Gear shift housing to body 10
Selector rod to transmission 25
Connecting rod to transmission 25
Push rod to transmission 40
Drive axle to drive flange M8
M10 40
80
Heat shield for drive axle 25
Clamp for exhaust pipe 40
Pa
ge 11 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.1

34-17

If the gear shift setting is incorrect it can be
adjusted as follows:

Note:
The angle of forwards/backwards inclination of the gear shift must not be
changed while the following adjustments are being made. - Loosen bolt for selector rod (arrow).

Tightening torques - Move gear shift to the left or to the right until distance "x" is 8.5 mm.
- Hold gear shift in this position.
- Tighten selector rod bolt. Component

Nm
Selector rod to selector fork (in selector mechanism) 25 - Check gear shift setting again.
- Fit covers and gear shift knob.
Pa
ge 17 of 17 Shift control mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.34.1