catalytic converter AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual

[x] Cancel search | Manufacturer: AUDI, Model Year: 1998, Model line: TT, Model: AUDI TT 1998 8N / 1.G
Pages: 35, PDF Size: 0.46 MB
AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual TT 1998 8N / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/951/w960_951-0.png AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual
Search: (tyre pressure, wheel alignment, clutch, automatic transmission fluid, air filter, lock)

Page 4 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-3 5 - Bolt 25 Nm (18 ft lb) 6 - Mount 7 - Gasket Always replace 8 - Nut Always replace30 Nm (22 ft lb) 9 - Gasket Always replace 10 - Turbocharger Removing and installing Page 21 -30

Page 10 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-7 All-wheel-drive vehicles 1 - Front muffler Factory-installed with rear muffler as one unit. If repair is necessary, replace separately Separating point Page 26 -16 Align exhaust syst

Page 27 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-21 Three Way Catalytic Converter (TWC), removing and installing Removing Note: Replace gaskets and self-locking nuts. Flexpipe in front exhaust pipe must not be

Page 29 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-22 - Remove air guide duct between cowl and air cleaner housing. - Remove air cleaner housing cover. - Remove the following lines/harness connectors: 1 - At wastegate bypass

Page 30 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-23 Installing Installation is the reverse of removal, noting the following: Only grease threads of oxygen sensor with "G 052 112 A3." Do NOT allow grease to get into slo

Page 35 of 35

AUDI TT 1998 8N / 1.G AEB ATW Engines Exhaust System Components Workshop Manual 26-28 Exhaust system, checking for leaks - Start engine and run at idle. - Seal tailpipes with cloths or equivalent for duration of leak test. - Listen for leaks at fol
Search: (wheel, compression ratio, infotainment, wheel size, length, steering)