climate settings AUDI TT ROADSTER 2015 Owners Manual

68 Warm and cold
The LE D in the buttons ill uminates when the
function is active .
Button(s) Meaning
Rotary Temperature selection
knob
(D ¢ page 68
Rotary Switch air conditioning on/off
knob @lil (
F an) ¢
page 68
Rotary Air distribution ¢ page 69
knob @
~ Defrost ¢ page 70
~
Rear window defogger
¢page 70
Heated seat* driver/passenger
I-..i +I side ¢ page 71
~ Recircu lation ¢ page 70
IA/Cl Switch on cooling system
¢page 70
Pollutant filt er
The pollutant filter (particle filter) ensures
that contaminants in the outside air (such as
d ust or pollen) are greatly reduced or stop­
ped. The air is also filtered in recircu lation
mode.
The po llutant filter element must be changed
according to the intervals specified in the
maintenance schedule so that the air condi­
tioning system's performance is not adversely
affected .
If the filter's effectiveness is weakened by
driving the vehicle in areas with heavily pollut­
ed outside air, the filter element should also
be changed in between the listed services.
A WARNING
For safety reasons, it is important that all
w indows are free of ice, snow, and conden­
sation. Only then is good visib ility ensured.
Please fam iliari ze yourse lf with the co rrec t
operation of the air conditioning and how
to de humidify/defrost the windows .
([) Note
-If you suspect that the clima te controls
have been damaged, swi tch the system off to avoid damaging it, and have it in­
spected by an authorized Audi dea
ler .
- Audi climate control system repairs re­
quire special expertise and the proper
tools . You should contact an authorized
Audi dealer in the event of malfunctions.
(D Tips
- To avoid adversely affecting heating and
cooling performance and to prevent con­
densation on the windows, the air intake
in front of the windshield must be free of
ice, snow, and leaves.
- The a ir coming from the vents and circu­
lat ing through the entire interior is ex­
tracted through the out let slots in the
side pane ls in the luggage compartment .
Make sure that the outlet slots are not
covered by clothing, etc.
- Climate contro l works most effectively if
the windows are closed. However, if the
inter io r of a par ked veh icle is ext reme ly
hot from the sun's rays, briefly opening
the windows can speed up the cooling process .
Setting temperature
.,. Turn the rotary knob (D ¢ page 67, fig. 78
to the desired temperature setting.
T o set a lower temperature, turn the rotary
knob to the left. To set a higher temperature,
turn the rotary knob to the r ight. There are
additional intermediate settings available to
adjust the temperature as needed.
Switching climate control on and off
Switching the climat e control sy stem on
and off
.,. Tu rn the knob@¢ page 67, fig. 78 to the
r ight to switch climate cont ro l on. The LED
next to the word O FF goes out.
.,. Turn the knob@¢
page 67, fig. 78 to the
left to switch the climate control system off.
The LED next to the word OFF comes on.
Iii>

Setting fan speed 8&
• Turn the knob@¢ page 67, fig. 78 to the
setting you want to adjust fan speed (a ir
quantity).
I n automat ic mode the cl imate control sys­
tem automatically regulates fan speed de­
pending on interior temperature. Yo u can ad­
just the volume of air produced by the fan to
meet your own requirements.
Air distribution
Fi g. 79 Inst rume nt pa ne l: Locat ion of ai r vents
• Turn the rotary knob@¢ page 67, fig. 78
to the des ired setti ng.
• To open a nd close the out lets, turn the ad­
justing ring .
• To ad just the direct io n of the airflow from
the outlet, move the tab in the center of the
outlet in the desired d irection. The direction
of the air de livered from the vents can be
adjusted horizontally and vertically.
A ir distribution :
- In sett ing
-0, air flows only to the w indows,
vents (!) and @are open . To defrost the
driver and front passenger side windows
most effectively, the vents @should be di ­
rected toward the side w indows.
- In sett ing®, a ir flows on ly to the dr iver/
passenger, vents ® and @ are open.
- In sett ing
-Or, air flows only to the footwell,
vents ® are open.
Warm and cold 69
@ Tips
If the difference between the desired tem­
perature set by you and the veh icle's interi­
or temperature is too great, the fan speed
will change automat ically. This is done so
that the des ired temperature setting is
reached as q uickly as possib le.
- I n setting~. air flows only to the windows
and the footwell, vents (!) , @ and ® are
open.
T he re are addit ional comb inat ions (thro ugh
i ntermediate settings) available to adjust a ir
dist ribution as needed.
{t) Tips
If the climate controls are running in cool­
i ng mode, air should flow mainly from
vents @and @. To achieve sufficien t cool­
i ng, you sho uld never close these ven ts
complete ly .