262
MobilityEngine compartment
>"Measuring engine oil level...":
This can take about 3 min utes if the car is at 
a standstill on a level surface and the engine 
is running, and about 5 minutes while the 
car is moving.
If engine oil was added,  it may take up to 
30 minutes to obtain  an oil level reading.
> "Engine oil level below minimum. Add 1 
quart!"
Add engine oil as soon as possible, but no 
more than 1 US quart/1 liter, refer also to 
Adding engine oil below.
If the oil level is below the minimum value, 
add engine oil immediately to avoid engine 
damage.
> "Engine oil level too high! Have this 
checked."
Too much oil will harm the engine. 
Have the vehicle  checked without 
delay. <
> "Measurement inactive. Have this 
checked."
Do not add engine oil. You can continue 
your journey. Note the newly calculated dis-
tance remaining to the ne xt oil service, refer 
to page 87. Have the system checked as 
soon as possible.
Adding engine oil
Add up to 1 US quart/1 liter  of engine oil only 
after a corresponding me ssage is shown on the 
Control Display.
Add oil within the next 125 miles/200 km; 
otherwise, the engine could be dam-
aged.< If the engine oil is to
o high, have the vehi-
cle checked immediately; failure to do so 
may result in engine damage.<
Keep oils, greases, etc. out of the reach of 
children and comply with the relevant 
warnings on the containers. Otherwise, health 
hazards may result. <
Oil grades to add
Do not use oil additives as this could 
result in engine damage.<
When selecting an engi ne oil, make sure 
to use one from the SAE viscosity classes 
0W-40, 0W-30, 5W-40 or 5W-30; failure to do 
so may result in malfun ctions or engine dam-
age.<
The engine oil quality is critical for the life of the 
engine.
Some oil grades may no t be available in all 
countries.
Approved oil grades
Additional information about approved oil 
grades is available at your BMW center.
Gasoline engine
BMW High Performance SAE 5W-30
BMW Longlife-01
BMW Longlife-01 FE
Diesel engine
BMW Longlife-04
Online  Edition  for Part  no. 01 40 2 609  333 - \251  08/11  BMW AG