jump cable BMW 5 SERIES 1989 E34 Workshop Manual

BMW 5 SERIES 1989 E34 Workshop Manual 5 SERIES 1989 E34 BMW BMW https://www.carmanualsonline.info/img/1/2759/w960_2759-0.png BMW 5 SERIES 1989 E34 Workshop Manual

Page 27 of 228

BMW 5 SERIES 1989 E34 Workshop Manual terminals and cable clamps after they are
assembled.
9Make sure that the battery carrier is in good
condition, and that the hold-down clamp bolt
is tight. If the battery is removed (see Chap-
ter 5 fo

Page 39 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 1 General information
This Part of Chapter 2 is devoted to in-
vehicle engine repair procedures. All
information concerning engine removal and
refitting and engine block and cylinder head
overhaul can

Page 48 of 228

BMW 5 SERIES 1989 E34 Workshop Manual applied. Tighten the retaining nut to the
specified torque to hold the tensioner in its
correct position. Note:It is important that the
timing belt is tensioned correctly. If the belt is
over-tightene

Page 82 of 228

BMW 5 SERIES 1989 E34 Workshop Manual disconnect the fluid cooler lines from the
radiator. Use a drip tray to catch spilled fluid.
Plug the fluid cooler lines and fittings.
7Disconnect the coolant sensors located on
the radiator (see illu

Page 85 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 4If a new sender unit is to be fitted, make
sure the engine is completely cool. There will
be some coolant loss when the unit is
unscrewed, so be prepared to catch it, or
have the new unit ready to fi

Page 92 of 228

BMW 5 SERIES 1989 E34 Workshop Manual Note 3:The following checks assume the fuel
filter is in good condition. If you doubt the
condition of your fuel filter, renew it (see
Chapter 1).
Note 4:In order to get accurate test results, it
is r

Page 93 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 19Depressurise the fuel system (see Sec-
tion 2).
20Detach the battery negative cable.
Caution: If the radio in your
vehicle is equipped with an anti-
theft system, make sure you
have the correct acti

Page 104 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 17 Throttle body- check,
removal and refitting
2
Check
1Detach the air intake duct from the throttle
body (see Section 8) and move the duct out of
the way.
2Have an assistant depress the throttle
peda

Page 105 of 228

BMW 5 SERIES 1989 E34 Workshop Manual gauge to the pressure regulator vacuum hose,
and check for vacuum (engine idling).
11If there is vacuum present, renew the fuel
pressure regulator.
12If there isn’t any reading on the gauge,
check t

Page 111 of 228

BMW 5 SERIES 1989 E34 Workshop Manual 5GeneralApplication
Models with carburettor or L-Jetronic fuel injection  . . . . . . . . . . . . . . Transistorised Coil Ignition (TCI) system
Models with Motronic fuel injection  . . . . . . . . . .
Page:   1-10 11-20 next >