sound system BMW 530I 2000 E39 Central Body Electronics ZKE Manual

Central Locking
Purpose of the System
The Central Locking System provides locking/
unlocking of the entire vehicle from one central
exterior point. From the driver’s door or the
remote (key-less) entry, a lock/unlock request will
lock/unlock all exterior doors, luggage compart-
ment and the fuel filler flap.
From inside, the vehicle can be locked/ unlocked using a cen-
tral locking button located in the center console. Individual
doors can be unlocked manually by pulling twice on the inte-
rior door handle.
From 2000 MY
- if the vehicle has been double locked, press
the central locking button and pull the interior door handle
twice (alarm will sound when the door opens).
Locking the vehicle from the central switch will “single lock” all
doors, luggage compartment and not lock the fuel filler flap.
The Central Locking System utilizes the GM III and Door Modules to carry out all of the lock-
ing/unlocking features:
• Remote (key-less) entry is standard.
• When locked from the outside, the vehicle will double lock and arm the DWA System. The
ignition must be switched off and the driver’s door must be opened and closed.
• Selective unlocking from the outside of the vehicle. Unlocking from the driver’s door or
remote transmitter will only unlock the driver’s door and disarm the DWA System. A sec-
ond request will unlock the remaining doors and luggage compartment. This feature can
be modified for individual users in Key Memory to open all doors from a single request.
• A single central locking button is installed in the center console that will operate when all
of the doors are closed. Locking the vehicle from the central switch will “single lock” all
doors, luggage compartment and not lock the fuel filler flap. When unlocking, a single
request will unlock the driver’s door only. This feature can be modified for individual users
in Key Memory to open all doors and luggage compartment from a single request.
17
Central Body Electronics ZKE III
12510117.jpg
12510118.eps

Anti-Theft (DWA) System
Purpose of the System
The DWA alarm system offers vehicle protection by monitoring the doors, hood, interior,
luggage compartment and vehicle tilting. When activated, DWA deters theft by sounding
an alarm siren for 30 seconds, flashing the low beam headlights (high beam on Xenon
equipped models) and four way flashers for 5 minutes.
The control electronics for DWA are integrated in the general module. The DWA - LED
indicator is located in the rear view mirror (E38 in the top center IHKA grille).
The system is “armed/disarmed” from the driver’s door lock cylinder, remote transmitter or
luggage compartment lock cylinder. The alarm is immediately deactivated when disarmed
with the key in the driver’s door lock cylinder (may be deactivated in Conversion) or remote
transmitter.
The GM utilizes existing components and/or circuits as part of the DWA system:
• Door latch switch/sensor contacts (door open/closed).
• Trunk lid switch contact (monitored for closed trunk).
• Trunk lock key position switch (located on the trunk lock, this switch signal prevents
DWA from activating if armed when the trunk is opened with the key).
• Hood switch (monitored for closed hood, located under the hood).
• DWA status LED (part of rear view mirror).
The additional components required are:
• Interior Sensor • DWA Siren • Tilt sensor
33
Central Body Electronics ZKE III
615200102.eps

Interior Sensor UIS (after 99 MY):Similar to the FIS, the UIS monitors the vehicle interi-
or for motion. The UIS uses ultrasonic sound wavs instead of microwaves (less suceptable
to magnetic interference). The UIS is a combined transmitter and receiver.
The interior sensor is mounted in the center of the headliner panel. Due to the design of the
vehicles interior, the sensor is uni-directional and must be installed in the proper direction
to ensure proper operation of the system (trim cover ensures directional installation).
Every time the DWA system is armed (signal STDWA), the sensor adapts to what ever
objects might be stationary in the interior. The sensor emits ultra sonic waves in a pro-
grammed timed cycle. It receives echos of the emitted waves.
The UIS amplifies the received sound wave signals and compares them with the transmit-
ted waves. The UIS also checks the incoming echos for background hiss (wind noise
through a partially open window) and adapts for this.
• If the echos are consistently similar, no movement is detected.
• If the echos are altered, (inconsistent), the UIS determines motion in the interior com-
partment.
If motion is detected, the UIS changes to a constant cycle and the echo is compared again.
If the inconsistency is still present the UIS sends the activate siren signal (INRS) to the GM.
The UIS is switched OFF when the vehicle is locked two times within ten seconds. The LED
will flash one time for confirmation. This allows the sensor to be switched OFF to avoid false
alarms when the windows are left open for venting.
35
Central Body Electronics ZKE III
615200105.eps

Alarm Indication
When the alarm is triggered, the siren will sound for 30 seconds. At the same time the low
beam headlights (high beams on Xenon equipped vehicles) and four way flashers for 5 min-
utes. The GM signals the LCM via the bus system to flash the lights.
Following an alarm activation, the system will reset and activate again if further tampering
occurs.
DWA LED Status:
Notes: _______________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
_____________________________________________________________________________
41
Central Body Electronics ZKE III
DWA STATUS DWA LED CONDITION
Disarmed OFF
Armed Continual slow flash
Armed with one or more monitored Rapid flash for 10 seconds,
inputs not in closed position then continual slow flash.
(ie: trunk not fully closed, etc)
Alarm activated Rapid flash for 5 minutes,
then continual slow flash.
Rearmed in less then 10 seconds. ON for 1 second
Disarmed after activated alarm Rapid flash for 10 seconds,
then OFF.