buttons BMW M5 2002 E39 Central Body Electronics ZKE Manual

• A remote luggage compartment button is installed in the left kick panel (center console
in the E53) to open the luggage compartment from inside the vehicle.
• The EWS is interfaced for double lock monitoring and unlock function. With the presence
of an accepted EWS key in the ignition, the vehicle will be unlocked and disarm DWA.
• The automatic locking feature (> 99 MY) activates the door locks when a road speed
signal of 5 MPH and engine RPM is detected via the K-Bus. The factory default setting
of this feature is off (can be encoded on for individual users with Key Memory function).
• In the event of an accident (ignition on), the GM will be signalled to unlock all doors.
Hardware Features:
• The external lock cylinders are located in the
driver’s door and luggage compartment lid
(E53/E39 Sport Wagon does not have a tail-
gate lock cylinder).
• The driver’s door and luggage compartment
incorporates an overrunning lock cylinder. The
lock cylinder will free wheel or spin If any key
other than the vehicle key or tool, such as a
screw driver, is inserted into the cylinder. The
lock cylinders can be manually locked/un-
locked by turning the key “past” lock/unlock.
• The door lock buttons are mechanically uncoupled from the
lock actuators when locked.
The door lock buttons “mechanically” lock the individual
doors. This provides manual locking in the event of a central
locking malfunction.
• Child safety locks (located in
the rear doors) are actuated
by inserting a key in the slot on
the door latch or by sliding a
lever (dependent on model).
The door can now only be
opened from outside.
18
Central Body Electronics ZKE III
Door
Button
Lock
12520117.eps
12520119.eps
12510121.eps
12520120.eps

System Components
Remote Key: Features:
• 3 volt lithium battery (commercially available CR 2016)
is used as the power supply for the key transmitters.
• An EEPROM is used to store the key data.
The data is not lost when the battery is re-
placed and initialization is not required.
• The key incorporates an LED that signals the opera-
tor of signal transmitting, key initialization status and
key self test indication.
• The keys are delivered
with a four color label
sheet containing differ-
ent colored labels for
each of the four pos-
sible FZV keys.
This is helpful to differenti-
ate the FZV keys during initialization preventing the pos
sibility of mis-assigning the key ID which would change
the encoded Key Memory functions.
Model Year 2000 Key
Visual Changes:
• New appearance with blue and white BMW roundel.
• New button arrangement (larger buttons) with seq-
uential operation (enhanced operating convenience).
Functions the same as the previous key.
• Rechargeable battery replaces replaceable batteries.
Charged by EWS ring antenna.
• The key housing is encapsulated and can not be
opened.
• The LED has been omitted.
29
Central Body Electronics ZKE III
615200049.eps 615200100.eps

Workshop Hints
Remote Key Initialization: The initialization of the FZV keys is required to establish the
Lock/Unlock signal synchronization with the GM. The initialization procedure provides the
GM with a key identification number and a “rolling code” for each key. If the initialization is
not performed, the GM will not respond to the key signals.
Up to 4 remote keys can be initialized. They must be initialized at the same time. Key ini-
tialization is only possible with the vehicle unlocked.
Procedure:
1. Close all doors and have all keys available.
2. Using key number 1, turn the ignition switch to KL
R, then switch off within 5 seconds and remove the
first key.
3. Within 30 seconds of turning the ignition switch to
“off” Press and holdbutton #2.
4. While holding button #2, press and release(“tap”)
button #1 three timeswithin 10 seconds.
5. Release both buttons. The LED in the key will flash
momentarily (except 2000 MY). The GM will imme-
diately lock and unlock the doors signaling a suc-
cessful initialization.
6. If additional keys need to be initialized repeat steps
3 - 5 within 30 seconds.
7. Switching the ignition to KL R completes the initiali-
zation.
NOTE: The key memory function of the GM responds
to the key identification number of each key. If the keys
are not initialized in the same order prior to initialization,
the key memory functions activated by the keys will not
be assigned correctly. Always initialize the keys in
the same order.
30
Central Body Electronics ZKE III
1
2
615200101.eps

LED Status (Keys equipped with LED):
The following functions can be checked with the LED:
• Flashing LED when pressing a button.
Indicates that the data is being transmitted.
(battery voltage between 3.2 - 2.6 volts)
• No LED activity when pressing a button:
1. ZKE responds to pressed button only to
unlock a locked vehicle. Indicates the bat-
tery is between 2.6 - 2.2 volts. Replace bat-
tery.
2. No unlock of vehicle. Indicates battery is
below 2.2 volts. Replace battery.
FZV Key Test: Pressing the trunk release and lock buttons together activates the key test. If
the battery and FZV key EEPROM are “OK”, the LED will come ON for approximately 1 sec-
ond.
FZV Key Rechargeable Battery
From KL R, the battery inside the key head is charged inductively by the EWS ring antenna
via a coil antenna integrated in the key. The charging process is controlled by electronic
circuitry integrated in the key.
• The service life of a radio-control key used under normal conditions corresponds to the veh-
icle lifespan.
• If the FZV keys are not used (ie: stored in a drawer), the battery will be discharged after
approx. 1.5 years.
• The time required to fully charge a discharged battery is approx. 30 hours.
• The remote control can be operated about 15 times after a charging period of approx. 30
minutes (driving time).
31
Central Body Electronics ZKE III