keyless BMW MOTORRAD CE 04 2021 Manual do condutor (in Portuguese)

Certifications
BMW Keyless Ride ID Device

USA, Canada:

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Canada:
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Product name: BMW Keyless Ride ID Device FCC ID: YGOHUF5750 IC: 4008C-HUF5750

Declaration Of Conformity

We declare under our responsibility that the product
BMW Keyless Ride ID Device (Model: HUF5750) camplies with the appropriate essential requirements of the article 3 of the R&TIE and the other relevant provisions, when used for its intended purpose. Applied Standards:
1. Health and safety requirements contained in article 3 (1) a) • EN 60950-1:2006+A11:2009+A1:2010+A12:2011; Information technology equipment-Safety 2. Protection requirements with respect to electromagnetic compatibility article 3 (1) b) • EN 301 489-1 (V1 .9.2, 09/2011 ), Electromagnetic compatibility and radio spectrum matters (ERM); Electromagnetic compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements • EN 301 489-3 (V1.4.1, 08/2002) Electromagnetic compatibility and radio spectrum matters (ERM); Electromagnetic compatibility (EMC) standard for radio equipment and services; Part 3: Specific conditions for short range devices (SRD) operating on frequencies between 9 kHz and 40 GHz 3. Means of the efficient use of the radio frequency spectrum article 3 (2) • EN 300 220-1 & -2 (V2.4.1, 05/2012), electromagnetic compatibility and radio spectrum matters (ERM); Short range devices (SRD); Radio equipment tobe used in the 25 MHz to 1000 MHz frequency range with power Ieveis ranging up to 500 mW; Part 1: Technical characteristics and test methods. Part 2: Harmonized EN covering essential requirements under article 3.2 ofthe R&TIE directive