tyre pressure BMW MOTORRAD K 1200 GT 2002 Rider's Manual (in English)
[x] Cancel search | Manufacturer: BMW MOTORRAD, Model Year: 2002, Model line: K 1200 GT, Model: BMW MOTORRAD K 1200 GT 2002Pages: 96, PDF Size: 6.59 MB
Page 29 of 96

22
27
Safety check
2
For this reason, check the
details in the following sections
before you start the journey:
– Fuel level
– Positions of the handlebar levers
–Brakes
–Brake fluid level
– Clutch fluid level
– Coolant level
– Shock-absorber setting and spring preload
– Wheel rim and tyre condition, tread depth and tyre
pressures
– Load, gross weight
–Lights
– Warning lights and indicator lights with ignition switched
on – Check regularly (every time
you stop for fuel), on the basis
of the following section:
– Engine oil level (every sec- ond/third stop for fuel):
– Brake pads
If you encounter any problems
or difficulties, it is always best to
contact your authorised BMW
motorcycle dealer.
He will provide the necessary
advice and assistance.
Checklist
10k41bkg2.book Seite 27 Donnerstag, 24. Juli 2003 9:17 09
Page 48 of 96

46
Safety check
2
Wheels
Checking tyre pressures
d Warning:
Incorrect tyre pressures have
a considerable influence on
handling and on tyre life.
Adjust tyre pressures to suit
total weight. Never exceed ei-
ther the motorcycle’s gross
weight or the individual wheel
load limits (b 49).
– When tyres are cold:
Remove valve caps
Check/correct tyre pressure Tyre pressures:
Front Rear
O n e - u p 2 . 5 b a r 2 . 9 b a r
(36.3 psi) (42 psi)
Two-up 2.5 bar 2.9 bar
(36.3 psi) (42 psi)
Two-up
with luggage 2.5 bar 2.9 bar (36.3 psi) (42 psi)
Fully tighten valve caps
Fully tighten valve caps
d Warning:
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Use only metal valve caps
with rubber seals.
Valve caps that are screwed
on well prevent air from es-
caping suddenly.
10k41bkg2.book Seite 46 Donnerstag, 24. Juli 2003 9:17 09
Page 55 of 96

22
53
Safety check
2
Headlight basic setting
L Note:
Do not prop the motorcycle on
the centre or side stand.
Check tyre pressures and cor-
rect if necessary.
Set the spring-strut adjuster to the position for one-up riding
–Make sure lever 2 is horizontal
(neutral position)
Position the motorcycle on a
level surface 10 metres (33 feet)
(headlight) from a light-coloured
wall, and with the rider's weight
(approx. 85 kg/187 lbs) on the
seat
Measure the distance H from
the ground to the centre of the
headlight
Transfer this height H to the wall
and draw a cross on the wall at
this point Draw a second cross
(x = 10 cm/3.94 in) lower
Switch on the low-beam headlight
Turn adjusting screw 1 to
align the headlight in such a
way that the light-dark cutoff
starts in the middle of the bot-
tom cross and rises to the
right to the height of the upper
cross, before dropping again
Adjusting screw 1: – Turn screw counter-clock-wise: higher
– Turn screw clockwise: lower
L Note:
Have the headlight basic set-
ting checked by a specialist
workshop, preferably an
authorised BMW motorcycle
dealer.
Lights
10k41bkg2.book Seite 53 Donnerstag, 24. Juli 2003 9:17 09
Page 65 of 96

3
63
Starting – Riding – Parking
Running in
Running in new brake
pads
d Warning:
New brake pads must “bed
down” and therefore do not
achieve their optimum friction
levels during the first 500 km
(300 miles).
This slight initial reduction in
braking efficiency can be
compensated for by exerting
greater pressure on the lever.
Try to avoid all unnecessary
hard braking during this initial
period.
e Attention:
Comply with the notes on BMW
Integral ABS (b 72-79).
Running in new tyres
d Warning:
New tyres have a smooth sur-
face. This must be roughened
by riding in a restrained man-
ner at various heel angles
until the tyres are run in.
This running in procedure is
essential if the tyres are to
reach their maximum level of
grip.
10k41bkg2.book Seite 63 Donnerstag, 24. Juli 2003 9:17 09
Page 93 of 96

91
Index
i
TTank cap, 4
Telltale and warning lightsABS, 7, 66
Battery charge current, 8
Battery charge light, 67
Coolant temperature, 8, 67
Cruise control, 7
Engine oil pressure, 8, 66
High-beam headlight, 8
Low fuel level, 8, 66
Neutral, 7
Turn indicator, right, 7
Telltale lights Turn indicator, left, 7
Toolkit, 4
Tools, 4, 20
Tread depth, tyres, 45, 46
Troubleshooting ABS, 79
Troubleshooting chart, 79
Turn indicator switch, left, 12
Turn-indicator cancel switch, 13
Tyres
Inflation pressure, 46
Running in, 63WWarning lightLow fuel level, 66
Warning lights
ABS, 66
Battery charge light, 67
Coolant temperature, 67
Engine oil pressure, 66
General, 66
Warnings
Braking, 70
T - Z
10k41bkg2.book Seite 91 Donnerstag, 24. Juli 2003 9:17 09