clutch BMW MOTORRAD K 1200 R 2006 Rider's Manual (in English)

ClutchChecking clutch
operationPull the clutch lever.
The pressure point must be
clearly perceptible.
If the pressure point is not
clearly perceptible: Have the clutch checked
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.Check the clutch fluid
levelMake sure the ground is
level and firm and hold the
motorcycle upright.
Move the handlebars to the
straight-ahead position.
with OA Centre stand:
Make sure the ground is
level and firm and place the motorcycle on its centre
stand.
Move the handlebars to the
straight-ahead position.
Check the clutch fluid level
in clutch fluid reservoir
1.
Wear of the clutch
causes the fluid level in
the clutch fluid reservoir to
rise. Clutch fluid level
Do not permit the clutch
fluid level to drop.
If the fluid level drops: Unsuitable hydraulic flu-
ids could cause damage
to the clutch system.
Do not attempt to top up
the system with fluids of any
kind.
Have the defect rectified
as quickly as possible by a
specialist workshop, prefer-
794zMaintenance

ably an authorised BMW
Motorrad dealer.The clutch system is
filled with a special hy-
draulic fluid that does not
have to be changed.TyresCheck the tyre tread
depth
Your motorcycle's hand-
ling and grip can be im-
paired even before the tyres
wear to the minimum tyre
tread depth permitted by law.
Have the tyres changed in
good time before they wear
to the minimum permissible
tread depth.
Make sure the ground is
level and firm and place the
motorcycle on its stand. Measure the tyre tread
depth in the main tread
grooves with wear marks.
Tyres have wear indic-
ators integrated into the
main tread grooves. The tyre
is worn out when the tyre
tread has worn down to the
level of the marks. The loca-
tions of the marks are indic-
ated on the edge of the tyre,
e.g. by the letters TI, TWI or
by an arrow.
If the tyre tread is worn to
minimum:
Replace tyre or tyres, as ap-
plicable.
RimsChecking rimsMake sure the ground is
level and firm and place the
motorcycle on its stand. Visually inspect the rims for
defects.
Have damaged rims
checked and, if necessary,
replaced by a specialist
workshop, preferably an
authorised BMW Motorrad
dealer.
WheelsApproved wheels and
tyresFor each size of tyre BMW
Motorrad tests certain makes,
and approves those that it
certifies as roadworthy. If
BMW Motorrad has not ap-
proved the wheels and tyres,
it cannot assess their suitab-
ility or provide any guarantee
of road safety.
Use only wheels and tyres ap-
proved by BMW Motorrad for
your type of motorcycle.
795zMaintenance

Paint careWashing the motorcycle
regularly will help counteract
the long-term effects of
substances that damage
the paint, especially if your
motorcycle is ridden in areas
with high air pollution or
natural sources of dirt, for
example tree resin or pollen.
Remove particularly
aggressive substances
immediately, however, as
otherwise the paint can
be affected or become
discoloured. Substances
of this nature include spilt
fuel, oil, grease, brake fluid
and bird droppings. We
recommend BMW vehicle
polish or BMW paint cleaner
for this purpose.
Marks on the paintwork are
particularly easy to see after
the motorcycle has been
washed. Remove stains ofthis kind immediately, using
cleaning-grade benzene or
petroleum spirit on a clean
cloth or ball of cotton wool.
We recommend that specks
of tar be removed with BMW
tar remover. Remember to
wax the parts treated in this
way.
Protective wax
coatingFor the protective wax coating
of paint, we recommend that
you use only BMW vehicle
wax or agents that contain
carnauba wax or synthetic
waxes.
It is time to rewax the paint-
work when water "puddles"
on the surface, instead of
forming beads.
Laying up the
motorcycleClean the motorcycle.
Remove the battery.
Spray the brake and clutch
lever pivots and the main
and side stand pivots with a
suitable lubricant.
Coat bright metal and
chrome-plated parts with
an acid-free grease (e.g.
Vaseline).
Stand the motorcycle in a
dry room in such a way that
there is no load on either
wheel.
Before laying the vehicle
up out of use, have the
engine oil and the oil filter ele-
ment changed by a special-
ist workshop, preferably an
authorised BMW Motorrad
dealer. Combine work for lay-
ing up/restoring to use with a
BMW service or inspection.
8124zCare

Technical data
Troubleshooting chart . . . . . . . . 128
Threaded fasteners . . . . . . . . . . . 129
Engine . . . . . . . . . . . . . . . . . . . . . . . 130
Riding specifications . . . . . . . . . 133
Clutch . . . . . . . . . . . . . . . . . . . . . . . 133
Transmission . . . . . . . . . . . . . . . . . 133
Final drive . . . . . . . . . . . . . . . . . . . . 135
Running gear . . . . . . . . . . . . . . . . . 135
Brakes . . . . . . . . . . . . . . . . . . . . . . . 136
Wheels and tyres . . . . . . . . . . . . . 136
Electrics . . . . . . . . . . . . . . . . . . . . . 137
Frame . . . . . . . . . . . . . . . . . . . . . . . 139
Dimensions . . . . . . . . . . . . . . . . . . 139
Weights . . . . . . . . . . . . . . . . . . . . . . 140
9127zTechnical data

Troubleshooting chartEngine does not start at all or is difficult to start.Possible causeRemedyKill switch activated. Kill switch in operating position (run).
Side stand extended and gear engaged. Retract the side stand ( 66).
Gear engaged and clutch not disengaged Select neutral or pull clutch lever ( 66).
Clutch pulled when ignition was OFF Switch on the ignition, then pull the clutch
lever.
No fuel in tank. Refuelling ( 71)
Battery not adequately charged. Charging battery when connected ( 116)
9128zTechnical data

Engine oil
Engine oil capacity, total3.5 l, With filter change
0.5 l, Difference between MIN / MAX marks
Lubricant Castrol GPS 10W-40 (SAE 10W40; API SG;
JASO MA)
Oil grades Mineral oils of API classification SF through
SH. BMW Motorrad recommends not using
oil additives, because they can have a detri-
mental effect on clutch operation. Please do
not hesitate to contact your authorised BMW
Motorrad dealer if you have any questions re-
lating the choice of a suitable engine oil for
your motorcycle.
Permissible viscosity classes
SAE 10 W-40 -20 °C, Operation at low temperatures
SAE 15 W-40 -10 °C
9132zTechnical data

Riding specificationsTop speed>200 km/hClutchClutch typeMultiplate clutch running in oil bathTransmissionGearbox typeClaw-shift 6-speed cassette gearbox, integ-
rated into engine block
9133zTechnical data

A
Abbreviations and symbols, 6
Anti-theft alarm, 18
B
BatteryBattery compartment, 13
Charging battery when
connected, 116
Charging battery when
disconnected, 117
Installation, 118, 119
Removal, 117, 118
Technical data, 137
Warning, battery charge
current, 28
Brake fluid Checking level, front, 91
Checking level, rear, 93
Brake lever Adjusting the handbrake
lever, 51
Brake pads Checking front, 90
Checking rear, 91 Brakes
Fluid reservoir, 13
Fluid reservoir, rear, 13
Front fluid reservoir, 13
Technical data, 136
Bulbs General instructions, 107
Replacing brake-light
bulb, 111
Replacing front turn
indicator bulbs, 113
Replacing high-beam
headlight bulb, 107
Replacing low-beam
headlight bulb, 107
Replacing parking-light
bulb, 109
Replacing rear light
bulb, 111
Replacing rear turn indicator
bulbs, 113
Technical data, 138
Warning, bulb failure, 29 C
Case
Adapting, 84
Adjusting, 82
Closing, 82
Installing, 84
Opening, 82
Removing, 83
Checklist, 66
Clock, 22 Adjusting, 44
Clutch Adjusting the clutch
lever, 51
Checking operation, 94
Fluid reservoir, 11
Technical data, 133
Confirmation of maintenance work, 145
D
Dimensions Technical data, 139
11152zIndex

S
SeatInstallation, 55
Lock, 11
Removal, 54
Service, 142
Service Card, 143
Side stand Starting the engine, 66
Spark plugs, 138
Speedometer, 18
Spring preload, rear Adjusting, 11, 58
Starter, 17
Steering lock, 41
Suspension damping, rear Adjusting, 11, 59
T
Technical data Battery, 137
Brakes, 136
Bulbs, 138
Clutch, 133
Dimensions, 139
Electrics, 137 Engine, 130
Engine oil, 132
Final drive, 135
Frame, 139
Fuel, 131
Running gear, 135
Spark plugs, 138
Transmission, 133
Weights, 140
Wheels and tyres, 136
Telltale lights, 18
Toolkit, 15 Service kit, 86
Standard kit, 86
Torques, 129
Transmission Starting the engine, 66
Technical data, 133
Troubleshooting chart, 128
Turn indicators Left, 16, 53
Right, 17, 54
Switching off, 17, 54 Tyre pressure control
(ReifenDruck-Control)
Label on wheel rim, 96
Operation, 46
Reading, 22
Tyres Approved, 95
Checking tread depth, 95
Checking tyre pressures, 62
Technical data, 136
V
Vehicle General view, left side, 11
General view, right side, 13
Laying up, 124
Restoring to use, 125
Vehicle identification num- ber, 13
W
Warning lights, 18
Warnings, 22 Mode of presentation, 23
Warnings, overview, 24, 32, 36
11155zIndex