high beam BMW MOTORRAD R 1150 R 2002 Rider's Manual (in English)

1
General information and controls
4
1Main (high) beam headlight
(
b 36-39)
2 Driving light (
b 36-39)
3 Front suspension strut,
shock absorber adjustment
(
b 40)
4 Reservoir for clutch fluid
(
b 35)
5 Engine oil filler (
b 21)
6 Rear spring strut,
spring preload (
b 41)
OEOptional equipment
7Rear spring strut,
shock absorber adjustment
(
b 40)
8 Power socket, 12 V
Provision for connecting
additional equipment –
max. load 5 A
9 Primary spark plug, left
10 Secondary spark plug, left
11 Main stand
OE (b 52, 53)
12 Oil level sight glass, engine
(
b 21)
( ) Figure in brackets
bpage number with explanation
General view, left side
1243657
8910
1112
10r28FUNbkg1.book Seite 4 Dienstag, 24. Januar 2006 9:31 09

1
General information and controls
7
1Telltale light, left turn indica-
tor repeater green
s
2 Warning light, battery
charge current red
r
(
b 61)
3 Telltale light, high (main)
beam blue
q
4Telltale light, neutral green
k (b 57)
5 Telltale light, right turn indi-
cator repeater green
t
( ) Figures in brackets bpage number
for description
6 Clock
Adjust by pressing with a
ballpoint pen or similar
object at
point A(minutes) or
point B (hours)
7 Warning light, general red
e (b 61)
8 Telltale light, Warning light
ABS
l OE (b 61)
OEOptional extra
* depending on national-market speci- fication
12435
8*7B6A
Telltale and warning lights
10r28FUNbkg1.book Seite 7 Dienstag, 24. Januar 2006 9:31 09

1
General information and controls
10
5
4
2
3
1
d Warning:
To prevent air from entering
the clutch system:
• Do not turn the fitting on the handlebar.
• Do not turn the handlebars
in the clamping blocks.
1 Cold start choke lever
(increased engine speed)
(
b 59)
2 Hazard warning flashers
switch (
b 12) 3
Horn button
4 Left turn indicator switch
•Press
– Turn indicators flash
To switch off:
• Press turn indicator cancel
switch 9
5 Headlight
FHigh (main) beam
GLow (dipped) beam
FHeadlight flasher
Left handlebar fitting
10r28FUNbkg1.book Seite 10 Dienstag, 24. Januar 2006 9:31 09

2
37
2
Safety checkAdjusting beam throw
L Note:
When the basic setting is cor-
rect, headlight beam throw is
regulated when spring preload
is adjusted to suit load.
Have the headlight basic set-
ting adjusted by a specialist
workshop, preferably an
authorised BMW motorcycle
dealer.
L Note:
Adjust beam height so that
oncoming traffic is not dazzled.
Make sure that the throw of the
light cone adequately illumi-
nates the road ahead of you.
Adjusting to suit load Change the spring strut setting
to suit the load ( (
b 41)
– Spring preload has an effect on headlight throw
Only if the load carried on the
motorcycle is very high, the
headlight beam can also be
lowered by moving pivot
lever 1. This shortens the beam
throw.
Pivot lever 1:
A = neutral position
B = high load
Lights
AB
1
10r28FUNbkg1.book Seite 37 Dienstag, 24. Januar 2006 9:31 09

2
39
2
Safety check
Lights
• Measure the distance H from
the ground to the centre of
the headlight
• Transfer this height H to the
wall and draw a cross on the
wall at this point
• Draw a second cross (x = 15 cm/5.9 in) lower
• Switch on the low-beam headlight
• Turn adjusting screw 1 to
align the headlight in such a
way that the light-dark cutoff
starts in the middle of the bot-
tom cross and rises to the
right to the height of the upper
cross, before dropping again. • Adjusting screw
1:
– Turn screw counter-clock- wise: higher
– Turn screw clockwise: lower
L Note:
Have the headlight basic setting
checked by a specialist work-
shop, preferably an authorised
BMW motorcycle dealer.
10r28FUNbkg1.book Seite 39 Dienstag, 24. Januar 2006 9:31 09

i
83
Index
GGear shifts, 62, 63
General viewleft side, 4
right side, 5
HHandlebar fittingleft, 10
right, 11
Handlebar levers, 24 clutch, 24
handbrake, 25
Hazard warning flashers, 12
Headlight beam throw adjustment, 36
Heated handlebar grips, 11, 12
Helmet holder, 13
High/low (dipped) headlight switch, 10
Horn, 10
Hydraulic fluid clutch, 35
IIgnition switch and steering lock, 6
function, 8, 9
Ignition, switching on, 56, 57
Installing System case, 18
Instruments, 6
KKill switch, 11
LLight general instructions, 36
headlight beam throw, 36
MMotorcycle equipment, 79
NNeutral, 57
OOctane number (fuel), 23
Oil filler, 21
Oil filler, engine, 4
Oil levelchecking, 21
engine oil pressure, 6, 60
sight glass, 4
Opening the System case, 16
Overheating, 58
PPartially integral brakes, 68
Power socket, 4
RRear brake brake fluid reservoir, 5
Removing System case, 17
Residual braking, 32
Residual braking function, 69
Rev. counter, 6
Rider's equipment, 78
G - H
10r28FUNbkg1.book Seite 83 Dienstag, 24. Januar 2006 9:31 09

i
84
Index
Riding, 62
Risk of overheating, 49
Running in, 55
SSafety check, 19
Safety instructionscatalytic converter, 49
general, 48, 49
Seat, 15 adjusting, 13, 14
closing the storage
compartment, 15
lock, 5
single, 15
Service worldwide, 76
Shock absorbers, 40
Side stand, 50, 51
Spring strut, 4
Starter button, 11
Starting the engine, 58
Storage compartment, 15
System case, 16
TTelltale and warning lights ABS, 7
battery charge, 7
engine oil pressure, 6
fuel level, 6
high (main) headlight beam, 7
neutral indicators, 7 Telltale lights
ABS, 61
battery charge, 61
engine oil pressure, 60
fuel tank level, 60
Toolkit, 5, 15
Tread depth, tyres, 42
Troubleshooting chart, 73
Troubleshooting, ABS, 73
Turn indicator switch left, 10
right, 11
Turn indicators
telltale lights, 7
Turn-indicator cancel switch, 11
Type plate, 5
Tyre pressures, 43
Tyre valve caps, 42
Tyres running-in, 55
VValve caps, 42
WWarning lightsABS, 61
battery charge, 61
engine oil pressure, 60
fuel tank content, 60
general, 61
Wheels, 42
R - Z
10r28FUNbkg1.book Seite 84 Dienstag, 24. Januar 2006 9:31 09