length BMW Z4 3.0SI ROADSTER 2007 E85 Owner's Manual
[x] Cancel search | Manufacturer: BMW, Model Year: 2007, Model line: Z4 3.0SI ROADSTER, Model: BMW Z4 3.0SI ROADSTER 2007 E85Pages: 132, PDF Size: 3.14 MB
Page 55 of 132
Reference
At a glance
Controls
Driving tips
Mobility
53
Malfunction
The warning lamp for the brake system
lights up in yellow. The drive-off assis-
tant has failed. The car will not be held
in place after the brake is released. Have the
system checked as soon as possible.
Flat Tire Monitor FTM*
The concept
The Flat Tire Monitor monitors tire pressures
while the car is being driven. The system
reports any significant loss of pressure in one
tire in relation to another.
In the event of tire pressure loss, the rolling
radius of the tire changes, thereby affecting the
rotational speed of the wheels. This change is
detected, and a flat tire warning is issued to the
driver.
System requirements
To ensure a reliable flat tire warning, the system
must be initialized with the correct tire inflation
pressures.
The system must be reinitialized each
time a tire inflation pressure has been cor-
rected or a wheel or tire has been changed.<
System limitations
The Flat Tire Monitor is unable to warn
the driver of sudden, severe tire damage
caused by external factors, nor can it identify
the gradual loss of pressure that will inevitably
occur in all four tires over a lengthy period of
time.<
The system could issue a false warning or func-
tion in a delayed manner in the following situa-
tions:
>System was not initialized
>Driving on a snow-covered or slippery road
surface
>Performance-oriented driving: slip at the
drive wheels, high levels of lateral accelera-
tion
>Driving with snow chains attached
Initializing the system
The initialization is completed while you
are driving, and can be interrupted at any
time. Initialization is continued automatically
when you continue driving.
When driving with snow chains, do not initialize
the system.<
1.Start the engine immediately before pulling
away, but do not drive off yet.
2.Press the button until the yellow indicator
lamp in the instrument cluster lights up for a
few seconds.
3.Drive off.
Initialization is completed during the drive,
without any feedback issued.
Flat tire warning
The warning lamp in the instrument
cluster lights up in red. A signal also
sounds. There is a flat tire or a signifi-
cant loss of tire pressure.
1.Cautiously reduce speed to 50 mph/
80 km/h or lower. Avoid strong braking and
steering maneuvers. Do not exceed a maxi-
mum speed of 50 mph/80 km/h.
If the car is not equipped with Run-
Flat Tires, refer to page88, the stan-
dard equipment by design, do not continue
driving. Otherwise a severe accident could
result after a tire puncture.<
2.At the next opportunity, check the air pres-
sure in all four tires.
If the inflation pressure is correct in all
four tires, it is possible that the Flat
Tire Monitor was not initialized. In this case,
initialize the system.<
Page 65 of 132
Reference
At a glance
Controls
Driving tips
Mobility
63
Air distribution
Direct the flow of air to the windows
, to the upper body area and to
the footwell . Intermediate settings
are possible.
Switching cooling function on/off
When the cooling function is on, the
air is cooled, dehumidified, then
reheated depending on the tempera-
ture setting.
Depending on the weather, the windshield may
fog over briefly when the engine is started.
Recirculated-air mode
If the air outside the car has an
unpleasant odor or contains pollut-
ants, temporarily shut off the supply
to the interior of the car. The system
recirculates the air within the vehicle.
If the windows fog over in the recircu-
lated-air mode, you should switch it off
and, if necessary, increase the air flow rate.
The manually controlled recirculated-air mode
should not be used continuously for lengthy
periods, otherwise the quality of the air inside
the car will gradually deteriorate.<
Temperature
For a higher temperature, turn the
rotary switch clockwise towards red.
For a lower temperature, turn the
rotary switch counterclockwise
towards blue.
Air flow rate
Adjust the air flow rate. The higher
the rate, the more effective the heat-
ing or cooling will be.
Switching the system on/off
Set the air flow rate to 0. Blower and air condi-
tioning are switched off and the air supply is cut
off.
To switch on the heater or air conditioning, set
any desired air flow rate.
Rear window defroster
The defroster switches off automati-
cally after a certain time.
Defrosting windows and removing
condensation
1.Air distribution1 in position .
2.Set air flow rate 2 to position 4.
3.Temperature3 to the right, red.
4.Switch on rear window defroster 4 to
defrost the rear window.
Ventilation
1Knurled wheels to set any vent position
from fully open to closed
2Slide for adjusting air flow direction
Ventilation for cooling
Adjust the vent outlets to direct the flow of cool
air toward you, for instance if it has become too
hot in the car.
Draft-free ventilation
Set the vent outlets so that the air flows past
you and not straight at you.
Page 123 of 132
Reference
At a glance
Controls
Driving tips
Mobility
121
Head restraints32
– removing32
– safe seating position30
Heated
– mirrors34
– rear window63,67
– seats33
Heating
– mirrors34
– rear window63,67
– seats33
Heavy loads, refer to Cargo
loading76
Height, refer to
Dimensions111,112
Height adjustment
– seats31
– steering wheel35
High beams60
– bulb replacement99
– headlamp flasher44
– indicator lamp12
High temperatures74
Holders for beverages69
Homepage of BMW4
Hood91
Horn10
Hot exhaust system74
Hydraulic Brake Assistant,
refer to Dynamic Brake
Control DBC51
Hydraulics, brake95
Hydroplaning75
I
Ice warning, refer to Outside
temperature warning48
Identification mark
– Run-Flat Tires88
– tire coding86
– tires88,89
Ignition, refer to Ignition
switched on40
Ignition key positions, refer to
Ignition lock40
Ignition keys, refer to The key
set18
Ignition lock40Imprint2
Inclines75
Indicator/warning lamp12
– airbags57
– alarm system24
– automatic transmission with
Steptronic43
– brakes13
– coolant temperature49
– DSC51
– DTC52
– engine oil level92
– engine oil pressure92
– engine temperature49
– fasten safety belts33
– Flat Tire Monitor53
– passenger airbags37
– reserve48
– Tire Pressure Monitor55
Indicator and warning lamps,
overview12
Individual vehicle
– equipment, refer to Your
individual vehicle5
Inflation pressure, refer to Tire
inflation pressure84
Inflation pressure monitoring,
refer to
– Flat Tire Monitor53
– Tire Pressure Monitor54
Initializing
– after power supply
interruption102
– Flat Tire Monitor FTM53
– windows25
Inspection49
Instrument cluster12
Instrument lighting60
Instrument panel, refer to
Cockpit10
Instrument panel, refer to
Instrument cluster12
Interior lamps61
– remote control19
Interior motion sensor
24
Interior rearview mirror34
– automatic dimming
feature34Interior temperature
adjusting63,66
Interlock, refer to Steering
locked40,42
Intermittent
– operation of the wipers45
Interval
– display, service49
J
Jack101
Jacking points102
Jets, refer to
Ventilation63,67
Jump-starting104
K
Key Memory18
Keys18
Keys, refer to The key set18
Key switch for passenger
airbags36
Kickdown43
Knee airbags56
Knock control83
L
Lamps59
Lamps and bulbs98
LATCH, child-restraint
mounting system38
Leather care, refer to the
Caring for your vehicle
brochure
LEDs Light-emitting
diodes98
Length, refer to
Dimensions111,112
License plate lamps, bulb
replacement101
Light-alloy wheels, care, refer
to the Caring for your vehicle
brochure
Light-emitting diodes
LEDs98