turn signal BUICK LACROSSE 2006 Get To Know Guide

A.AirOutlets
B.InteriorLampsControl
C.ExteriorLampsControl
D.TurnSignal/MultifunctionLever
E.AudioSteeringWheelControls
F.InstrumentPanelCluster
G.DICButtonsH.PassengerAirBagStatus
Indicator
I.AudioSystemControls
J.HoodRelease
K.ParkingBrake
L.CruiseControlsM.Horn
N.SteeringWheelClimateControls
O.ClimateControls
P.ShiftLever
Q.AccessoryPowerOutlet
R.GloveBox
Getting to Know YourLaCrosse2
InstrumentPanel
SeeSection3ofyourOwnerManual.

Getting to Know YourLaCrosse6
Remote Vehicle Start
(if equipped)
Use the Remote Keyless Entry transmit
ter (key fob) to start the engine from out
side the vehicle. (See the Driver
Information Center personalization menu
section to enable.) Automatic Climate
Control system vehicles will regulate the
inside temperature.
To remote start the vehicle:
1. Press and release the key fob Lock
button.
2. Press and hold the (Remote Start)
button until the turn signal lights flash.
If the lights are not visible, hold the
Remote Start button for four seconds
and release.
The engine runs for 10 minutes. Extend
run time for 10 minutes from present by
pressing the Lock and Remote Start but
tons again. Pressing only the Remote
Start button again will turn off the igni
tion. Maximum run time is 20 minutes.
After two remote starts have been pro
vided, the Remote Vehicle Start feature
will not operate.
See Section 2 of your Owner Manual.
Unlocking the Doors with the Key
Your vehicle’s passenger doors can be
unlocked using the driver’sdoor key.
With the key in the lock cylinder:
• Turn the key toward the front of the
vehicle to unlock the driver’s door.
• Turn and hold the key toward the
front of the vehicle for two seconds to
unlock all doors.
• Turn and hold the key toward the rear
of the vehicle to lock all doors.
See Section 2 of your Owner Manual.
Headlamp Controls and
Automatic Headlamp System
You will find the exterior lamps knob on
the left side of the instrument panel.
(On/Off):If the switch is in the AUTO
position but lights are off, turn them on
by turning the switch to (On/Off) and
release. To turn the headlamps off when
the lights are on, turn the control to the
position. The momentary switch
design springs back to AUTO when
released.
AUTO:Activates the automatic head
lamp system, illuminating all exterior
lamps and the instrument panel/radio
lights when needed.
(Parking Lamps):The parking lamp
position illuminates tail/side marker/
license plate lamps and instrument
panel/radio lights.