height BUICK LESABRE 2004 Get To Know Guide

7
Power Seat Controls
Adjust Seat Height and Cushion
Position
Push the horizontal control forward or
rearward to move the entire seat forward
or rearward. Move the entire horizontal
control up or down to move the entire
seat up or down. Move the front of the
horizontal control up or down to adjust
the front portion of the seat cushion up
or down. Move the rear of the horizontal
control up or down to adjust the rear
portion of the seat cushion up or down.
Reclining Front Seatbacks (optional)
Move the vertical control forward or rear-
ward to move the seatback forward or
rearward.
4-Way Power Lumbar Control
(optional)
Press the power lumbar control forward
or rearward to increase or decrease
support. Press the control up or down to
move the lumbar support up or down.
See Section 1 of your Owner Manual.
Heated Seats (optional)
The HEATED SEAT buttons are located
on the driver’s and front passenger’s
door panels. Press the button to turn the
heated seat to the HIGH setting. The
button will illuminate. Press again to
select the LO setting.
Pressing the button again turns the
heated seat off.
See Section 1 of your Owner Manual.
15778 LeSABRE GUIDE 5/22/03 1:54 PM Page 7

15
Press the image height adjuster control
up or down arrow to raise or lower the
HUD image on the windshield to suit
your personal preference.
See Section 3 of your Owner Manual.
Universal Transmitter (optional)
Programmable Universal Transmitter
You can program up to three transmit-
ters. The vehicle’s engine should be
turned off during programming.
To erase any previous settings:
Press and hold the two outside buttons
simultaneously until the indicator light
flashes rapidly. Release the buttons.Hold your hand-held transmitter against
the bottom surface of the Universal
Transmitter (UT) so you can see the
indicator light.
Choose one of the three buttons to
program. Press and hold the transmitter
button and the UT button until the
indicator light flashes rapidly (this could
take up to 90 seconds). Release both
buttons.
Operate Universal Transmitter
Press and hold the appropriate button.
The light will illuminate while the signal
is being transmitted.
PASS-Key
®III
The PASS-Key®III is a passive theft-
deterrent system that provides your
vehicle with a higher level of security by
offering 3 trillion electronic security
codes.
Asingle key opens all locks and oper-
ates the ignition. A transponder is locat-
ed in the key. With the key in the igni-
tion, the transponder is activated and
emits an encoded signal. This signal
allows the engine to start.
Note:Make sure people and objects
are clear of the garage door you are
programming.
15778 LeSABRE GUIDE 5/22/03 1:55 PM Page 15