windshield wipers BUICK PARK AVENUE 1994 Owners Manual

With the ignition key in the ignition switch, you can turn
the switch to five different positions:
(A) Accessory: This position lets you use things like the
radio and the windshield wipers when the engine is off.
To use, push in the key and turn it toward you. Your
steering wheel will remain locked, just as
it was before
you inserted the key.
(B) Lock: Before you put the key in, your ignition will
be
in the Lock position. This position locks your
ignition, steering wheel and transaxle. It’s
a theft
deterrent feature.
(C) Off: This position lets you turn off the engine but
still turn the steering wheel. It doesn’t lock the steering
wheel like Lock.
Use “Off’ if you must have your car in
motion while the engine is off.
(D) Run: This is the position for driving.
(E) Start: This key position starts your engine.
NOTICE:
If your key seems stuck in “Lock” and you can’t
turn
it, be sure it is all the way in. If it is, then turn
the steering wheel left and right while you
turn
the key hard. But turn the key only with your
hand. Using a tool to force
it could break the key
or the ignition switch. If none of this works, then
your vehicle needs service.
80
ProCarManuals.com

The Turn SignallHeadlight Beam
Lever
The lever on the left side of the steering column
includes your:
0 Turn Signal and Lane Change Indicator
0 Headlight High-Low Beam & Passing Signal
0 Windshield Wipers
Windshield Washer
Cruise Control
Turn Signal and Lane Change Indicator
I'
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you
to signal a turn or a lane change.
To signal a turn, move the lever all the way
up or down.
When the turn
is finished, the lever will return
automatically.
94
ProCarManuals.com

A green arrow on the
instrument panel will flash
in the direction of the turn
To signal a lane change, just raise or lower the lever
until the green arrow starts to flash. Hold it there until
you complete your lane change. The lever will return by
itself when you release
it.
As you signal a turn or a lane change, if the arrows don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the green arrows don’t go on at all when you
signal a
turn, check the fuse (see “Fuses” in the Index)
and for burned-out bulbs. If you
have a trailer towing option
with added wiring for
the trailer lights, a different turn signal flasher is used.
With this flasher installed, the signal indicator
will flash
even
if a turn signal bulb is burned out. Check the front
and rear turn signal lights regularly to make sure they
are working.
Operation of Lights
Although your vehicle’s lighting system (headlights,
parking lights, fog lamps, side marker lights and
taillights) meets all applicable federal lighting
requirements, certain states and provinces may apply
their own lighting regulations that may require special
attention before you operate these lights.
For example, some jurisdictions may require that you
operate your fog lamps only when your lower beam
lights are also on, or that headlights be turned on
whenever you must
use your windshield wipers. In
addition, most jurisdictions prohibit driving solely
with
parking lights, especially at dawn or dusk. It is
recommended that you check with your own state or
provincial highway authority for applicable lighting
regulations.
95
ProCarManuals.com

Headlight High-Low Beam
BRIGHT
Windshield Wipers
To change the headlights
from low beam to high or
high to low,
pull the turn
signal lever toward you.
Then release
it. When the
high beams are on, this blue
light on the instrument
panel also will be on. You
control the windshield wipers by turning the band
marked
“WIPER.”
For a single wiping cycle, turn the band to “MIST.”
Hold
it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the band on “MIST” longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful
in light rain or
snow. Turn the band to choose the delay time. The
closer to
“LOW,” the shorter the delay.
For steady wiping at low speed, turn the band away
from you to the
“LOW” position. For high speed
wiping, turn the band further,
to “HIGH.” To stop the
wipers, move the band to “OFF.”
Remember that damaged wiper blades may prevent you
from seeing well enough to drive safely.
To avoid
damage, be sure to clear ice and snow from the wiper
blades before using them. If they’re frozen to
the .
windshield, carefully loosen or thaw them. If your
blades become damaged, get new blades or blade
inserts.
Heavy snow or ice can overload your wiper motor.
A
circuit breaker will stop the motor until it cools. Clear
away snow or ice to prevent an overload.
96
ProCarManuals.com

Windshield Washer
At the top of the multifunction lever there’s a paddle
with the word “PUSH” on it. To spray washer fluid on
the windshield, push the paddle for less than a second.
The washer will spray several times, then stop. Unless
they are already turned
on, the wipers will operate at
low speed for several sweeps, then turn
off.
To get more fluid on the windshield, push .and hold the
paddle. Spraying will continue as long as the paddle is
held.
WASHER
FLUID LOW
If this light comes on,
it means you’re low on
washer fluid. Driving
without washer fluid can be dangerous.
A bad
mud splash can block your vision.
You could hit another
vehicle or go
off the road. Check your washer fluid level
often.
97
ProCarManuals.com

Look at the silver-colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure
you
replace a bad fuse with a new one of the identical size
and rating.
There are additional fuses located behind the right sound
insulator panel on the passenger side. If these require
service, see your Buick dealer.
Maxifuse/Relay Center
To check the fuses in this underhood fuse center, turn
the two knobs
1/4 turn counterclockwise and remove the
cover. There is a chart inside the cover that explains the
features and controls governed by each fuse and relay.
The PASS-Key
II@ fuse is located in the right side relay
center.
Headlights
The headlight wiring is protected by a circuit breaker in
the underhood fuse center. An electrical overload will
cause the lights to go on and off, or in some cases to
remain off. If this happens, have your headlight wiring
checked right away.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse. If
the motor overheats due to heavy
snow, etc., the wiper will
stop until the motor cools. If
the overload is caused by some electrical problem and
not snow, etc., be sure to get it fixed.
Power Windows and Other Power Options
Circuit breakers in the fuse panel protect the power
windows and other power accessories. When the current
load is too heavy, the circuit breaker opens and closes,
protecting the circuit until the problem
is fixed or goes
away.
278
ProCarManuals.com

Turn Signalmeadlight Beam Lever ................... 94
Turn Signal Indicator
.............................. 94
Twilight Sentinel ................................ 104
Underbody Maintenance
......................... 274
Universal Theft Deterrent
.......................... 76
Unleaded Gasoline
............................... 229
Upholstery Care
................................. 268
Used Oil Disposal
............................... 243
Vehicle Identification Number (VIN)
............... 276
Vehicle Loading
................................. 258
Vehicle Storage ................................. 255
Ventilation
..................................... 14 1
Vinyl. Cleaning ................................. 270
Voltage Indicator
................................ 129
warning Flashers. Hazard
........................ 196
Warning Lights
.................................. 120
AirBag
...................................... 36
Anti-lock Brake System
........................ 123
Battery
...................................... 128
Brake ....................................... 122
ChangeOilSoon
.............................. 127
CheckOilLevel
.............................. 126
Door Ajar
................................... 130
Engine Coolant Temperature
.................... 124
Engineoil
................................... 125 LightsON
................................... 103
LowCoolant
................................. 125
LowFuel
.................................... 121
Safety Belt
................................... 25
Security ...................................... 76
Service Engine Soon (Malfunction
Traction Control System
........
Trunk Ajar ...................
Washer Fluid Low .............
Washer. Windshield ..............
Washing Your Vehicle ............
I ndicator Lamp) . . 128
............... 123
............... 130
................ 97
............ 97. 251
............... 272
Weatherstrips 273 v ...................................
Weight
Gross Axle Weight Rating (GAWR)
............... 259
Gross Vehicle Weight Rating (GVWR)
............ 259
Trailer
...................................... 190
Wheel
Alignment
................................... 265
Aluminum
................................... 273
Cover Removal
............................... 217
Replacement
................................. 266
Windows
....................................... 93
Windshield
Cleaning
.................................... 272
Washer
...................................... 97
Washer Fluid
................................. 251
Wipers
....................................... 96
Winter Driving
.................................. 184
WreckerTowing
................................. 203
Your Driving and the Road
........................ 161
Your Vehicle and the Environment .................. 285
NutTorque
.................................. 223
319
ProCarManuals.com